Electronics Forum | Fri Oct 28 04:56:12 EDT 2016 | lilybell
I read a few posts here about resistor in led applications. The thing is, the resistor has clarified as this shows:was always use with a power source delivering a higher forward voltage than the led could tolerate(ex: a 9volt battery hook up to a 3w
Electronics Forum | Wed Jan 30 02:56:22 EST 2019 | robl
I'm with Steve and flying probing. As long as you are testing the capacitance of the cap in the circuit and not of the cap itself you'll get a pretty good indication. Most are going to be 10nf and 100nf decoupling caps at that size so quite easy to
Electronics Forum | Tue May 26 22:13:15 EDT 1998 | Pat Copeland
R&D is currently designing a board with smt components on both sides of the board. They are adding a 16 pin IC Gull wing. on the bottom side of the board. I have asked for only caps and resistors to be placed on the bottom side. Is there a recommende
Electronics Forum | Tue Jan 14 11:02:59 EST 2003 | soupatech
I found a feeder with a 2mm pitch and was told that although it was made for the CP4, it would work with the CP3. Before we throw out a thousand bucks, has anyone had experience loading parts off of a 2mm pitch tape with the CP3? The part is a 1.6
Electronics Forum | Fri Apr 01 14:51:23 EDT 2011 | jaimebc
We are currently experiencing a high rate of false calls on our 0402 chips. Resistors for the most part. Has anybody out there found a setting where this false calls are minimized? We are using top red light, pattern inspection,color inspection ( wh
Electronics Forum | Tue Jan 29 10:17:02 EST 2019 | bane016
I want to know how you measure capacitance and resistance to 01005 components?Is there such a machine for automatic measurement of component values on PCB? We have a lot 01005 components and we lose time to measure first panel components...I'm inter
Electronics Forum | Wed Jan 30 03:20:00 EST 2019 | bane016
We measure each first board before the oven after every chageover...Assembling one offset and measure component, after we clear plate...We have reason why do that...But we're wasting a lot of time.So I wanted to see how you do it. Thank you for answe
Electronics Forum | Sun Jun 07 09:43:11 EDT 1998 | Bob Willis
There are some guidlines on design and through hole reflow on my web site to download. Also on pin in hole reflow the SMTA Office has a document on using the tecnology. | R&D is currently designing a board with smt components on both sides of the bo
Electronics Forum | Tue Sep 22 16:39:10 EDT 2009 | rmitchell
Hi, We are getting a E-Hydra-1 Frame grabbing failed on caps and resistors and also a Light Curtain trigger X wagon. I spoke with mydata and they indicated the light curtain might be getting set off and causing the frame grabbing failure. I cleane
Electronics Forum | Fri Apr 08 06:12:06 EDT 2011 | don7888
Thanks Reese. To be honest I don't know a great deal about the software just yet but we are running version 2.7.4. I know the guys are saying that they have a problem with identifying small capacitors and resistors as these have no markings though t
