Electronics Forum | Thu Dec 29 05:56:37 EST 2005 | bobpan
Dont quote me on this because its been a while but i believe thats a grounding issue on the quad-align card itself. The card is located in the rear right bottom of the machine. Try adding a ground wire to the cage that the card is mounted inside. Als
Electronics Forum | Thu Jun 30 13:49:15 EDT 2011 | jholif
I am seeing a motor error 4 intermittently during operation. Sometimes it happens as soon as a program starts, sometimes it will perform 1-6 placements and then stop with it. I have swapped the stepper motor driver cards, the EPCU card, the SRX card
Electronics Forum | Mon Dec 30 21:38:56 EST 2013 | jkoughan
I've got a scary one for you guys and desperately need your help - We just purchased a second Quad 4C and had some communication problems when we first turned it on (we're still working on that issue). To chase down the problem, we decided to start
Electronics Forum | Fri Apr 12 19:20:25 EDT 2013 | microaide
Some progress, now stuck again. I can now generate a pick and place program for two heads that actually runs the head 1 program when loaded into the central controller of machine #1. But all attempts at getting machine #2 to run the head 2 program ha
Electronics Forum | Wed Sep 25 09:59:44 EDT 2013 | bobpan
Hello, This is from my old documents....hope it helps. I would first try mod code 53 = 2 first.....if the machine is a 2C. The motor was known for causing this problem after getting old. These are all resolutions for motor error 4. Step Potential P
Electronics Forum | Wed Sep 04 09:47:41 EDT 2019 | smrsteve
Hello All, I've just bought a Quad 4c pick & place machine. It's so close to actually building boards, but just doesn't quite get there. I was wondering if there's somebody out there with experience of these machines that might be able to help...?
