Electronics Forum | Mon Feb 28 08:34:46 EST 2005 | Alex
Good advises thanks. I'll go thru all nozzles and vacuum check today and tell the programer about PD's and nozzle vs shutter. Should I check at the same time all the vacuum filter ? For the placement test, we use the same feeder at the same position.
Electronics Forum | Tue Mar 01 10:27:24 EST 2005 | Rob
Hi Alex, I've seen 2 types of feeder test rigs for sale that cover CP6 feeders, one from Alternative - http://www.alternativesmt.co.uk and one called a GAM20 - I think it was ABtech Europe - http://www.abtech-europe.com. The GAM20 was about half th
Electronics Forum | Thu Feb 24 12:08:15 EST 2005 | siverts
Checked the condition of your nozzles? Vacuum ok? Dummy part picked from the same feeder position? Dummy part picked from the very same feeder? How often does this problem occur? How many dummys did you pick for comparison? Sometimes a feeder calibr
Electronics Forum | Wed Jun 24 16:10:09 EDT 2020 | landrysmt
Hello, Finaly, What was the problem on your Hydra head? Maybe my message comes too late, but my answer might help ... It could be linked to a problem with the Hydra Z motor / encoder. In certain circumstances, the Hydra Z axis is not in the correct
Electronics Forum | Fri Feb 25 16:34:53 EST 2005 | jimmyb
In your PDs you must specify a single nozzle size. Meaning don't assume that entering nozzle size max=1.3 and nozzle size min=1.3 forces the machine to use a 1.3. Nozzle size min is not used in the CP6 software (it only uses nozzle size max), there
Electronics Forum | Fri Mar 26 06:58:06 EDT 2010 | ristikas
Hello, We have here very oftenly one error in our MPM Accuflex. I dont know who to ask about that errors... The error is „The transfer light peam interlock has been broken. Remove the obstacle from the path of the beam.“ I checked the sensors and
Electronics Forum | Wed May 18 12:20:27 EDT 2005 | Tech
We have a panasonic MSR and keep getting collation errors and not sure how to remedy without shuttingdown machine and starting over. Any suggestions would help? Thanks.
Electronics Forum | Tue Mar 30 05:27:06 EDT 2010 | accuspares
Hi, Can you tell me at what point in the print cycle the error happens and if it consistently happens at the same point? The machine has two crash beams running down either side of the machine as a safety measure to ensure the table is down before
Electronics Forum | Thu Sep 23 14:39:10 EDT 2010 | markgray
What is the exact message on the screen?
Electronics Forum | Mon Sep 20 06:29:27 EDT 2010 | darrenleebs
i have an old contact 3av pick and place machine that has started to display placement head position errors. the machine seems to start working if you switch it on and leave it for a couple of hours to warm up. has anybody had simillar issues with th