Electronics Forum | Wed Mar 08 10:52:27 EST 2000 | Wolfgang Busko
Hi Jacqueline, for the "manufacturing allowance" IPC says FAB.TOL. is the board manufacturing tolerance and PLACE ACRCY is the pick and place accuracy. For 0,8 mm pitch they give for both values 0,1 mm. Solder joint design goal data comes from empir
Electronics Forum | Mon Jun 25 20:37:14 EDT 2001 | davef
You are 100% correctamundo that the pad on PCB should be the same as the pad on the BGA interposer, but let�s not expend that thinking to the aperture of your solder paste stencil, right away. Generally, paste on large pitch BGA is often 1:1, but as
Electronics Forum | Fri Mar 03 06:41:09 EST 2000 | jacqueline coia
I have tried the IPC calculator and they do not have this type of component registered. When trying to select 'other' on menu, no connection can be made. The polarity if the QFP has not been decided yet (pre-PCB design) the pitch size of the componen
Electronics Forum | Fri Mar 03 06:41:09 EST 2000 | jacqueline coia
I have tried the IPC calculator and they do not have this type of component registered. When trying to select 'other' on menu, no connection can be made. The polarity if the QFP has not been decided yet (pre-PCB design) the pitch size of the componen
Electronics Forum | Wed Jul 25 10:57:08 EDT 2007 | cecil
Our board layout folks are currently designing a PWB using a 132 QFN. The component is .5mm pitch with .35mm square pads. The component manufacturer recommends the following footprint: .4mm square land .3mm square solder resist 1.why do they spec
Electronics Forum | Thu Apr 02 11:19:41 EST 1998 | Justin Medernach
| I am looking for footprint details on a SM crystal. | Package type - Golledge GSX49-4. | Solder method - refolw Mark, Check with the good folks at IPC for land design. The spec should be IPC-SM-782. Also, see http://www.ITM-SMT.com. It's Phil Za
Electronics Forum | Fri Mar 03 10:07:15 EST 2000 | Wolfgang Busko
Hi Jacqueline, - what a name in this technical world - I just tried the calculator and for example choose the CQFP and then selected other and an input mask appeared where you have to fill in the required data from the components datasheet. I have to
Electronics Forum | Fri Mar 03 10:07:15 EST 2000 | Wolfgang Busko
Hi Jacqueline, - what a name in this technical world - I just tried the calculator and for example choose the CQFP and then selected other and an input mask appeared where you have to fill in the required data from the components datasheet. I have to
Electronics Forum | Thu Sep 15 21:36:52 EDT 2011 | darby
I also posted this in the design section... G'day folks - haven't been around for some time but still soldering on. Question for y'all. One of my design engineers has shown me a Creative PCI audio card with a TQFP48 attached. 0.4mm pitch. Let's say
Electronics Forum | Thu Sep 15 21:25:43 EDT 2011 | darby
G'day folks - haven't been around for some time but still soldering on. Question for y'all. One of my design engineers has shown me a Creative PCI audio card with a TQFP48 attached. 0.4mm pitch. Let's say the pin width is 0.2mm and the pad design ha
