Electronics Forum | Sun Jan 19 10:45:04 EST 2003 | davef
For laminated FR4 PCB, we bake between 6 and 24 hours at 100�C. [Search for other bake recipes in the fine SMTnet Archives.] Alot of the determination of baking time is a function of: * Amount of moisture absorbed. * Amount of moisture you need to r
Electronics Forum | Wed Aug 07 08:46:38 EDT 2002 | davef
The time and temperature required for baking moisture from your boards varies according to the conflicting desires to: * Remove enough entrapped moisture. * Desire to retain solderability of solderable surfaces. Search the fine SMTnet archives for s
Electronics Forum | Wed Mar 29 04:14:49 EST 2000 | Marc
Charlie B: You mentioned that you have an air conditioned environment and a RH 0rf 50, baking the boards is predominately done when the history of the PCB delivery and / or previous storage conditions are un known. When I was with a CM, we did this a
Electronics Forum | Mon Feb 15 14:28:09 EST 1999 | Andy Bellworthy
Any info on the pros and cons of FR4 or Polyamide ref the use of soldering PGAs would be helpful. ie. temp co-efficient diffs, baking, wave soldering, Convection reflow etc
Electronics Forum | Tue Feb 16 12:26:07 EST 1999 | S. Rose
| Any info on the pros and cons of FR4 or Polyamide ref the use of soldering PGAs would be helpful. ie. temp co-efficient diffs, baking, wave soldering, Convection reflow etc |
Electronics Forum | Wed May 13 07:24:12 EDT 1998 | Sherry
Does the temp. profiles used to reflow double sided pcb's through a IR oven on FR4 board material have to be re-established if it is changed to polyimide? Boards will be baked out prior to assembly. any response would be most appreciated.
Electronics Forum | Thu May 14 04:11:33 EDT 1998 | JACK CHEN
| Does the temp. profiles used to reflow double sided pcb's through a IR oven | on FR4 board material have to be re-established if it is changed to | polyimide? Boards will be baked out prior to assembly. | any response would be most appreciated.
Electronics Forum | Fri May 31 10:35:46 EDT 2002 | dason_c
I think that the IPC spec only apply to the MSD. I had a paper from Lucent and forwarded by Francois Monette, please aware that the first 2 hours, the moisture doesn't bake out from the assembly/component and result show that it is increase the weigh
Electronics Forum | Mon Dec 08 17:06:59 EST 2008 | boardhouse
Hi MGL, Couple things to ask, have the boards recently been changed to Rohs builds? STD FR4 to High TD Laminate. Check the stack-up the board houses are using. Just about all Rohs laminate has Resin starvation issues when used in single ply co
Electronics Forum | Thu Jun 15 21:51:17 EDT 2000 | Dave F
Jeff: You're correct �7.1.3 of ANSI J-STD-001C states " Drying / Degreasing states the assembly may be treated to remove moisture and other volitiles." We don't bake "FR4" for love nor money. The archive are littered with threads along this line.