Electronics Forum | Fri Jul 17 19:43:20 EDT 2009 | fujiphil
Have you eliminated the hardware N.G.? Check the connection for the rear door. If the connection are ok, try to bypass the key. short the two wires for the rear door. If the rear door problem is corrected, check the rear door switch physically. Reg
Electronics Forum | Tue Apr 11 08:41:44 EDT 2017 | jdengler
Do you have an interlock bypass key? If you do can you reset the interlock in bypass? If you cannot, I believe there is a pico fuse on the interlock pcb in the control panel that may have blown.
Electronics Forum | Sat Sep 25 09:00:59 EDT 2010 | slwolbert
I managed to bypass this issue by flushing FIP2 and sending status and proper back.
Electronics Forum | Mon Nov 08 21:29:46 EST 2021 | bpoydence
Hi Everyone I recently started a new position at a small company. One of my tasks is to get a Hakko FR1418 rework station up and running. Unfortunately they do not have the "Software Protection Key". The machine does not operate without it. Hakk
Electronics Forum | Wed Apr 29 16:13:53 EDT 2009 | jimmyboz
Hit the help key while cursored on that category,(televideo monitor) if the sticker wore off, its one of the keys in the upper right, below the the F keys, above the number key pad, let me know if you got it.
Electronics Forum | Mon Dec 19 16:47:19 EST 2005 | Steve
Bert: Try this: Set Servo Press Axis Key # 4 to prompt machine ID Hold in Axis key # 1 and input ID (typically 0 - check machine proper) Release ID key, continue to Hold #1 key Press Release #1 key Then Release You will now be able to Jog the Tray
Electronics Forum | Tue Dec 13 19:33:06 EST 2022 | proceng1
Does yours have the removeable hard drive that unlocks with a key and the whole thing comes out? Try plugging the HDD directly in, and don't use the adapter part. It's kind of tricky, but I was told by the service techs that a bunch of those adapt
Electronics Forum | Mon Sep 20 14:47:59 EDT 2010 | dman97
DEKHEAD, Thanks for the repies. I have checked and re checked both cover switches, and both are making contact. I have even stuck bypass keys into both slots and still i get nothing. When you say it is an IO error, how would I go about checking t
Electronics Forum | Wed Apr 09 13:07:35 EDT 2008 | mulder0990
Our maintanence department just made keys out of FR4 if I have seen the keys correctly. Just an idea
Electronics Forum | Wed Apr 09 10:53:16 EDT 2008 | cyber_wolf
Does anyone know where I can get the male portion of the Fuji lockout switches ? Thanks