Electronics Forum | Wed Jul 15 10:37:58 EDT 1998 | Ben Salisbury
| | We just have a use cp4 .I have a problem on transfering data between cp3 to cp4 .when I use the data for cp4 I can't have parts in correct location. Is that normal? or it's because that has a different vision system.if so.how can i do with it.the
Electronics Forum | Sat Aug 18 10:06:05 EDT 2012 | cyber_wolf
There is no defined method that I am aware of. If your bulbs are old replace them. Other than that adjust the gain and offset until there is clear definition on the edges of the components. Keep an eye on the dump box.If the dump box stays relatively
Electronics Forum | Thu Oct 29 17:43:46 EST 1998 | Guillermo Villegas
Does anybody know how to update a different nozzle than the standard one on a Fuji IP3 machine? I want to use a 15.8 mm height nozzle, but the limit on height size is 10 mm for IP3.I know, I need to use a special nozzle, so I�m trying with a 16.00 m
Electronics Forum | Thu Sep 07 14:01:17 EDT 2000 | Murad Kurwa
Best bet is to use Tecnomatics Unicam software. This is similar to Fujicam that I believe comes with Fujis. Initial part library comes with all the insdustry standard part classification. For new parts / odd parts you can add to the library. Try www
Electronics Forum | Thu Aug 31 17:47:47 EDT 2000 | lucky
I do not understand what you are asking for????
Electronics Forum | Thu Oct 02 01:59:06 EDT 2008 | edmaya33
Obviously nobody can help you Jack. 1. its the camera for parts recognition ( enhanced CMOS ). 2. positioning system upgraded from ball screw to linear motor/gantry. before CPH=16500 new CPH=18000 using H12S
Electronics Forum | Thu Sep 07 12:52:30 EDT 2000 | Doug
Which fuji machines do you have? The new manuals are pretty easy to follow, if you have them. SMD3 machines have the SMD3 Manual 7.1E and the BGA/Connector manuals available. Contact fuji training for more details. Otherwise, if you have certain ques
Electronics Forum | Fri Oct 30 18:47:19 EST 1998 | phillip hunter
| Does anybody know how to update a different nozzle than the standard one on a Fuji IP3 machine? | | I want to use a 15.8 mm height nozzle, but the limit on height size is 10 mm for IP3.I know, I need to use a special nozzle, so I�m trying with a 1
Electronics Forum | Tue Aug 31 13:54:50 EDT 1999 | David Spilker
Do any SMTneters out there have a good solution to substitute SMT parts that you are willing to share? I presume all of us have the issue where purchasing wants to buy "the same part" from a different vendor. While the part may be the same electrical
Electronics Forum | Thu Jul 22 07:30:21 EDT 2010 | nitronica1
does anyone know where I can get replacement conveyor/drive belts for a Fuji/astro pcb 0.5m conveyor? pref from the UK or europe the length of the belts are approx 630mm and 6mm wide, flat with bumps on bottom side