Electronics Forum | Mon Jul 28 19:03:53 EDT 2003 | Ryan Liao
Hi mantis, Thank you for your helps. I had checked the CP7 error code index application. It also gives me the same answer. It tell me " the part pickup status is bad" and I have to "Make sure that the nozzle is not bent and that the part is being pro
Electronics Forum | Fri Mar 13 15:00:18 EDT 2009 | dman97
Can somebody take a look at this screen shot and tell me what it is supposed to mean. Every time I try to transmit this program to my CP642 machine I get this error. Does any one know what this error means and how would I correct it? Thanks for yo
Electronics Forum | Tue Feb 16 08:47:38 EST 2010 | jdengler
We powered up our CP-IV today and got an error. About 7 seconds after power on page 000 comes up with nothing in any of the areas except for second status area which contains "LD INIT" in yellow. After about 16 seconds the second display area gets
Electronics Forum | Mon Jan 16 09:50:38 EST 2023 | mra
Hi Fern, I'm getting the same error on my CP40 and cannot clear it as well, did you finally find out what to do to solve it? Thanks in advance!
Electronics Forum | Thu Sep 09 13:41:43 EDT 2021 | fernsure
Tried suggested solution in manual to no avail. Reseated every connector we could get to. Has anyone run into this error, and found a solution? This error does not allow me to ignore this head and use the other two. Thanks Fern
Electronics Forum | Wed Aug 22 15:48:03 EDT 2012 | rmitchell
Hi, Our CP8 is down with this message. Parameter: EMG FjMcEmgservoEnable CAM(0),FjlSrvAxis Reset R=304087143 The machine error also has possible broken wire. None of the servo amps show an error they are all (bb) on the led read out We do not hav
Electronics Forum | Sat Sep 28 15:58:38 EDT 2013 | sonavc
Hi. 'm new to this Fuji CP3, I bought this machine in working condition ( I saw it ran, but I forgot to check the board in and out ).... Moved to my location, Problem: When the board is trying to load to the X-Y table, it passed the conveyor B but
Electronics Forum | Tue Oct 01 05:10:20 EDT 2013 | anilw2006
Please go to output from I/O option and press on/off option in the main conveyor. While on condition motor should on when off motor should stop.If this will not happen then need to change I/o card.
Electronics Forum | Wed Oct 02 07:43:21 EDT 2013 | aj
could be a faulty motor? you can check the voltage at the connection to the motor when the IO is on.....or swap the motor.
Electronics Forum | Wed Oct 02 00:35:33 EDT 2013 | sonavc
thanks I tested the conveyor A or B , when it is on the motor turn and the green LED at the out put card is also light on. But when i turn on the X y table motor , the green LED is on , but the motor is not run. I will try to replace the I/O
