Electronics Forum | Fri Aug 13 14:52:15 EDT 2004 | cabjerk
Hi All: I posted this thread a while back and got no response. So, I'm trying it again. We have found a machine called the GAM-20F to calibrate our Fuji CP6 feeders. Has anyone ever used one of these? The price is in the 5-6K range and is from SMT
Electronics Forum | Thu Jul 21 01:29:07 EDT 2005 | matjen
We are using Fuji-Flexa software and we are not sure where to go in the software to check the proper data. If anyone has Fuji-Flexa software and could direct us in the right direction please let me know. Thanks.
Electronics Forum | Wed Jun 10 10:38:51 EDT 2015 | cyber_wolf
The published Fuji CP6 placing accuracy specification is plus/minus .1mm I would say that your machine is running just fine.
Electronics Forum | Wed Jun 29 09:05:38 EDT 2005 | jdengler
Try http://www.smtresearch.com/ But the price is not much cheaper than new ones.
Electronics Forum | Wed Jun 29 19:25:02 EDT 2005 | matjen
I found a place that exchanges old nozzles for new ones; thanks for the inputs though.
Electronics Forum | Thu Jun 30 10:11:47 EDT 2005 | Stefan
Here is another one: http://www.cotinc.com/product_range.htm
Electronics Forum | Thu Jun 11 07:26:20 EDT 2015 | linux
Think you right, not enough to be worried about. Thanks for all your help.
Electronics Forum | Tue Jun 28 19:56:20 EDT 2005 | matjen
I am in the process of searching for anyone that does repair on fuji cp6 nozzles .7 & 1.0 mainly, We have an abundance of bent and broken nozzles that I would like to get repaired rather than throwing out so if anyone has information on this please
Electronics Forum | Sun Jun 07 19:16:54 EDT 2015 | linux
Hello everyone, I'm looking for help with placement issue on our cp6 Fuji. On occasion we have to adjust co ordinates on the x and y axis usually about 0.12mm. Ball screw was replaced did not fix issue. Anything else we could try. Thanks everyone
Electronics Forum | Wed Jun 29 03:47:12 EDT 2005 | fastek
I'm confused. Aren't Fuji nozzles like $20 each? Why bother? I would hope you understand that a nozzle not properly repaired could cause $50 worth of rework in about a minute after you installed it. Stepping over dimes to pick up pennies comes to min
.gif)
