Electronics Forum | Wed Nov 03 12:57:28 EDT 2010 | adrianam
I need some help with the following alarm appeared on Fuji FCP4-3 : ,,Servo Amplifier alarm on X, Y, C, Z axis". When I push the reset button, remain ,,Servo Amplifier Alarm on D, F theta axis". All the sensors and solenoid it were checked and is OK
Electronics Forum | Tue Apr 13 20:44:31 EDT 1999 | Jeff Cealey
| I am begining to evaluate hi speed chip shooters. We are interested in the Panasonic MV2E. Does anyone have any experience with the turret style placement equipment, Panisonic in particular. | Thanks, | Jeff For turret machines, you should conside
Electronics Forum | Tue Feb 16 08:47:38 EST 2010 | jdengler
We powered up our CP-IV today and got an error. About 7 seconds after power on page 000 comes up with nothing in any of the areas except for second status area which contains "LD INIT" in yellow. After about 16 seconds the second display area gets
Electronics Forum | Mon Jan 10 03:12:27 EST 2005 | technitelec
are you looking for a used one or a new one, may i know what is the exact Fuji number is it fcp4-2 or fcp4-3 machine??? thank you serge
Electronics Forum | Sat May 27 14:09:23 EDT 2000 | do ngoc hung
MAY YOU HELP ME TO SOVLE THE PROBLEMS IN MACHINE. I CAN NOT CHECK NOZZLES IN CENTER, BRIGHTNESS MODE OR THE CCD CAMERA CAN NOT CAPTURE THE NOZZLES. SO MAY I HAVE ANY INFO ABOUT IT. PLS GIVE ME A ADVICE ASAP VIA EMAIL. THANKS AND BEST REGARDS. DO
Electronics Forum | Tue Sep 14 17:15:30 EDT 2010 | daxman
Hi Steve, I don't have any experience with CP2's. Sorry .. hazarding a guess though... if they use the analog servo amps like they do in the CP4's, they had a bunch of trimmer pots on them. There is a procedure to zero them using the mecca check mod
Electronics Forum | Sat Sep 11 08:19:54 EDT 2010 | slwolbert
Greetings: I am having 'Check Servo' issues with an FCP 2 4000. It will zero set but given a few minutes afterwards, the check servo alarm sounds. At times the X/Y table will 'coast' back to beginning position, like the power has been cut to the
Electronics Forum | Tue Sep 21 18:46:24 EDT 2010 | slwolbert
Greetings: > > I am having 'Check Servo' issues > with an FCP 2 4000. It will zero set but given a > few minutes afterwards, the check servo alarm > sounds. > > At times the X/Y table will 'coast' > back to beginning position, like the power
Electronics Forum | Thu Sep 16 18:43:57 EDT 2010 | slwolbert
Hello Daxman, Thanks for the input. Yes, the CP2 is closely related to the CP4 and does have the analog servo amps as you deduced. I did a wiggle test on the connectors and found that the x-y-r servo amp alarmed right away and blinked the x axis a
Electronics Forum | Thu Jun 15 05:41:40 EDT 2006 | anil wagh
Is fuji cp6 machine capabile for glue process? Regards, Anil wagh