Electronics Forum | Fri Nov 20 23:00:07 EST 1998 | David Lombard
| | Thanks for your reply. | | I am interested in knowing about maintenance schedules and levels. I'm wondering how to know if I must replace a part. What part? What type of lubrication (for Fuji). Etc. | | My company is small in terms of number of
Electronics Forum | Wed Jul 15 10:37:58 EDT 1998 | Ben Salisbury
| | We just have a use cp4 .I have a problem on transfering data between cp3 to cp4 .when I use the data for cp4 I can't have parts in correct location. Is that normal? or it's because that has a different vision system.if so.how can i do with it.the
Electronics Forum | Wed Jul 15 06:32:03 EDT 1998 | Process Engineer
| We just have a use cp4 .I have a problem on transfering data between cp3 to cp4 .when I use the data for cp4 I can't have parts in correct location. Is that normal? or it's because that has a different vision system.if so.how can i do with it.the d
Electronics Forum | Wed Jul 04 12:22:07 EDT 2001 | davef
Several points: * Consider that your Cpk is probably different for both placing large and small components. * Probably your routine placement rate SB the speed you use to monitor the accuracy of your process. * Some people use a calibrated glass test
Electronics Forum | Fri Oct 29 15:20:24 EDT 2004 | nxt
Thanks, however this is not the technology that I'm interested in. Bartector is for setup verification of feeders. I am in need of a feeder vendor that can provide a feeder to present a barcode label to a placement machine for placement onto a pcb
Electronics Forum | Fri Oct 29 14:48:46 EDT 2004 | nxt
I was interested in obtaining any information from anybody who is utilizing a barcode label feeder in their SMT placement machine process. I have heard a lot of good things about Hover-Davis and was wondering if anyone had input on other barcode lab
Electronics Forum | Mon Jan 30 01:46:16 EST 2006 | ____
1) The Binary vision system does not like many variables. 2) I believe that to be a firmware bug. Find out what version you are running and contact either Fuji America Corporation or Fuji Japan directly. You are better off trying FAC.
Electronics Forum | Fri Jan 27 11:03:53 EST 2006 | bvdb
We are a New Zealand company that purchased a used Fuji IP-1 locally. There is no Fuji support here but we've managed to get the IP-1 up and running with just the use of the manuals. There are many things that the manuals do not explain and I would
Electronics Forum | Wed Jun 10 10:38:51 EDT 2015 | cyber_wolf
The published Fuji CP6 placing accuracy specification is plus/minus .1mm I would say that your machine is running just fine.
Electronics Forum | Mon May 19 11:10:59 EDT 2008 | cyber_wolf
AJ. The mechanical clamping units on the xyz table are notorious for slipping on these machines.