Electronics Forum | Thu Jun 10 07:44:41 EDT 2010 | jdengler
Did the machine work when you first installed it? Have you done a reset start yet? Make sure you have air applied when you power up. The IP's don't like to power up without the air.
Electronics Forum | Tue Aug 15 10:55:23 EDT 2006 | chrisgriffin
Some software versions won't allow a brightness change with the next button. You should do a histogram test. Place a board on the worknest, then a smooth white card on top of that. Then jog the camera over the card. Raise the Z-axis to it's softwa
Electronics Forum | Mon Jul 17 20:50:42 EDT 2017 | davef
For service related problem, contact Dave Byker at 847-913-0162
Electronics Forum | Wed Jul 12 17:05:22 EDT 2017 | rodrigo
Hi all, Our Fuji cp6 woke up with a bad power supply (ps) this morning. The ps is one of two 24vdc (Corsel P300E-24). There is one inside the cabinet and one on the door where the cpu card is. The bad one is the one inside the cabinet. So we had anot
Electronics Forum | Wed Aug 27 12:38:48 EDT 2014 | fuji_user_2014
We do a lot of low volume prototypes and several boards that have have cut outs or fixtures that dont always reliably stop squarely at the in carrier (beveled corners). This sometimes results in a fid read error, because the fid wont be in the search
Electronics Forum | Fri Jan 11 16:26:57 EST 2008 | rschnic
Thanks for the reply. We have software. It just won't connect when the Fuji controller (Flexa) is powered on. It appears that the controller ties up the GEM port. We were wondering if there is something that needs to be reconfigured or shutdown o
Electronics Forum | Thu Aug 22 13:31:23 EDT 2013 | bvdb
Re-doing this thread as original seems to have been shortened. Our beloved 24 year old Fuji IP-1 fine placement machine won't start. Has been working fine for the past 6 years but now when the Power button is pressed the power comes on but the FAIL
Electronics Forum | Mon Apr 26 15:52:11 EDT 2010 | markhoch
If the above recomendations do not help...(I'd try them first) Did you try the infamous "Fuji Fix"? Power the machine all the way down and power it back up. (Rebooting the software)
Electronics Forum | Tue Nov 11 18:41:21 EST 2003 | mantis
Hey all, Anybody out there able to shed some light on the above error.My Mpav powers up with this error and wont let me do anything the manual is not much help either. Regards, Mantis
Electronics Forum | Tue Feb 16 08:47:38 EST 2010 | jdengler
We powered up our CP-IV today and got an error. About 7 seconds after power on page 000 comes up with nothing in any of the areas except for second status area which contains "LD INIT" in yellow. After about 16 seconds the second display area gets