Electronics Forum | Wed Feb 09 22:33:27 EST 2000 | Dave F
All: I don�t think this isn�t what Charlie was asking about, but since he�s got our juices flowing on the topic, does anyone have a sense about running paste and adhesive at the same time, beyond the issues that we spoke about in responding to Charl
Electronics Forum | Thu Feb 10 16:00:31 EST 2000 | Travis Slaughter
I have had cases when it was necessary to run epoxy and paste at the same time. The only good reason I know of to even think about messing with going to this trouble is if the surface tension of the solder melting pulls the part out of alignment. T
Electronics Forum | Tue Feb 08 16:09:09 EST 2000 | dean
Generally speaking with most electronic grade epoxies: 1. Cure time is a function of temperature. 2. Polymer bonds begin to quickly break down above certain temperatures (product specific). I believe aprox 170-180C. The strength of the bond de
Electronics Forum | Tue Aug 04 11:10:22 EDT 1998 | Chrys
| Hi Stoney, | Justin is giving you some good advice, unfortunately these kinda' problems sometimes call for the ol' D.O.E...otherwise, you could be chasing your tail for a while until you figure out exactly what's causing your problems. | Has
Electronics Forum | Wed Oct 17 10:21:08 EDT 2001 | genglish
Cheers guys for your rapid response, I investigated the problem further today, eventually I cam round to curing the adhesive in a sandwich of microscope slides resting on the PCA in question (hopefully mimicking the heat transfer), the adhesive is sp
Electronics Forum | Thu Oct 26 15:13:16 EDT 2023 | cyber_wolf
Try 3616 or 3609. Both of these become pliable when heat is applied.
Electronics Forum | Wed Dec 20 04:43:36 EST 2006 | greg york
Any decent flux would volatise off with the heat of the wave unless absorbed into the solder mask. Test this by trying to clean in alcohol or common solvent aerosol, if it does not clean then it is probably Mineral Salts from solder mask fillers. Ano
Electronics Forum | Wed Sep 21 12:30:03 EDT 2005 | Rob
Hi Greg, We've used lots of machines over the years & seen lots of different tape related issues - the main one being snap off of the cover tape, usually due to too much glue, over entusiastic heat seal, or a feeder requiring maintainance. Also the
Electronics Forum | Sun Apr 25 12:05:50 EDT 1999 | Chrys Shea
| | | Has anyone had trouble waving and gluing 0603 R's and C's? At my company, our designers have "opened the floodgates" on bottom-side 0603's. | | | | | | We've got an EPK+ with rotary chip and omega wave but can't seem to get skip-free solderin
Electronics Forum | Mon Apr 26 09:18:27 EDT 1999 | C.K.
| | | | Has anyone had trouble waving and gluing 0603 R's and C's? At my company, our designers have "opened the floodgates" on bottom-side 0603's. | | | | | | | | We've got an EPK+ with rotary chip and omega wave but can't seem to get skip-free so