Electronics Forum | Fri Apr 17 07:45:43 EDT 1998 | Robert Meston
We have to mount our SMD devices 0.1 to 0.4 mm off the pcb PCb substrate to compensate for thermal stressing in a Space enviroment. Has any one any ideas or contacts for dissolvable pads. this only applies to leadless components
Electronics Forum | Fri Apr 17 14:37:13 EDT 1998 | Justin Medernach
| We have to mount our SMD devices 0.1 to 0.4 mm off the pcb | PCb substrate to compensate for thermal stressing in a | Space enviroment. Has any one any ideas or contacts for | dissolvable pads. this only applies to leadless components Robert, Try
Electronics Forum | Wed Oct 26 14:29:55 EDT 2005 | barryg
We have a class 3 assembly we will be doing soon and I was wandering since the fillet heighth required for class 3 is 50% more than class 2, should I have my stencil thickness increased from 6 mil. to 7 mil.? This assembly is made up of 31 mil. pitch
Electronics Forum | Fri Jan 24 08:14:24 EST 2014 | davem
m_imtiaz, Over the last 15 years or so I've found that using the stencil foil thickness +2mils/-0mils has worked very well. For example, if you have a 5mil stencil thickness your upper control limit would be 7mils and your lower control limit would
Electronics Forum | Sun Apr 19 13:52:45 EDT 1998 | D.Lange
| We have to mount our SMD devices 0.1 to 0.4 mm off the pcb | PCb substrate to compensate for thermal stressing in a | Space enviroment. Has any one any ideas or contacts for | dissolvable pads. this only applies to leadless components Robert, PPI
Electronics Forum | Sun Apr 19 13:50:41 EDT 1998 | D.Lange
| We have to mount our SMD devices 0.1 to 0.4 mm off the pcb | PCb substrate to compensate for thermal stressing in a | Space enviroment. Has any one any ideas or contacts for | dissolvable pads. this only applies to leadless components Robert, PPI
Electronics Forum | Thu Mar 31 06:09:19 EST 2005 | amstech
Yes, components do contribute to the non wets in fine pitch reflow. Oxidation is the main culprit. May ask where it is coming from. Can not say in particular. May be burn in test process or end of line baking, hot / cold testing and need to run DOE'
Electronics Forum | Tue Apr 28 14:50:43 EDT 1998 | Chrys
| | We have to mount our SMD devices 0.1 to 0.4 mm off the pcb | | PCb substrate to compensate for thermal stressing in a | | Space enviroment. Has any one any ideas or contacts for | | dissolvable pads. this only applies to leadless components | Ro
Electronics Forum | Thu Mar 17 09:56:34 EST 2005 | jmedernach
Tx, Your spec limit is the point at which you expect to see a failure. In other words, what is the probability that you'll see a short when you have .008" of solder paste? What is the probability that you'll see an open if you have .004" of solder
Electronics Forum | Thu Sep 14 06:18:00 EDT 2023 | deniseburton
Hello, mcdvoice It seems like your Juki RS-1R machine's laser height calibration may be off. When measuring a 0402 resistor, it consistently reports heights around -0.60 to -0.70, causing pickup issues during production. Manually adjusting it to -
