Electronics Forum | Tue Feb 03 02:55:04 EST 2015 | max83
Hi, > > We have a snap-off issue. I guess it can > be linked to z calibration. > Hi, > > We have a snap-off issue. I guess it can > be linked to z calibration. > Hi, > > We have a snap-off issue. I guess it can > be linked to z calibration.
Electronics Forum | Thu May 24 12:55:19 EDT 2007 | pjc
First off, go with HiE (Hi Efficiency) machines only. UP3K and UP2K have huge differences- board size, speed, options, etc... too many to list really. I would recommend UP2K HiE over UP3K HiE. Its a simpler machine and easier to find on the used m
Electronics Forum | Fri Dec 09 16:04:15 EST 2005 | valuems
Hi Rick Your right and I a agree with you. But I think there is to many people looking at the HiE machines, when all they need is a UP2000. The only advantage of the HiE machines is that they are quicker. But they seem to have a couple of problems
Electronics Forum | Sat May 30 07:06:42 EDT 2015 | et1972
Hi I have a MPM3000HI printing machine with a following problem : Unable to run at high speed for z axis ,machine will stop at certain points . Have change ballscrew,nut ballscrew,motor and brake but still the same. Now run at low speed at 1 but t
Electronics Forum | Thu Feb 16 05:49:28 EST 2017 | endruw18
Hello everyone.Ihave an Intel 855pm Northbridge and when i removed the chip,i lifted 4 pads one of them is VSS so i dont care it but the 3 other is:HI 4 ,HI8 and HI 6 (hub interface for cmos i/o or simply hub interface ).Are the vital or only testing
Electronics Forum | Wed Jun 21 03:58:46 EDT 2000 | Wolfgang Busko
Hi Dave, how does that calculate when you consider a topside temperature of for example 120�C like mentioned for NC-flux a while ago and a pot temperature of 250�C ? Just wondering Wolfgang