Electronics Forum | Tue Jul 27 12:45:34 EDT 2010 | kmtan
Hi expert, we have one lead frame product proposed to send to flux clean recently. The problem here is the frame is attached with high temp tape. After flux cleaning the frame, the tape turns out deformed in which we think it was due to chemical reac
Electronics Forum | Fri Jan 21 11:28:39 EST 2011 | nucleartoast
I worked for Electrovert for 20 years and up till today the 1421 is still the oil of choice. The chain doesn't care who's oven it's running in but it does require regular lubrication.
Electronics Forum | Thu Jan 27 05:36:37 EST 2011 | 15009
We use it and have had no issues on either oven. 1 Conceptronics, 1 Heller.
Electronics Forum | Tue Feb 01 14:18:20 EST 2011 | markyen
We have Heller oven for over 8 years now and we use Heller industries Inc. Edge holder chain lube Part number: 680784 Overon F232-iso vg 220
Electronics Forum | Sun Aug 28 22:15:45 EDT 2005 | iwan
I agree with Pete, I prefer to use High Temp Lubricant. Because it more clean compare to High Temp Grease. Usually i only do a few drip for 3-5 days, because purpose of lubricant is to make chain & shaft smooth.Since Biral is expensive lubricant i us
Electronics Forum | Tue Aug 23 14:23:00 EDT 2005 | pjc
Most ovens I know use oil to lubricate conveyor chain, not grease. Anyway, is this what you're using: NMG No Melt Grease NLGI 2 (operates from -20�C to +270�C) NMG is a long-fibred highly adhesive grease which does not melt or drip at high temperat
Electronics Forum | Tue Aug 23 14:25:50 EDT 2005 | pjc
Here's the oil: BIO 30 - Biral Industrial oil (operates to +300�C ) BIO 30 is an extremely high quality synthetic industrial oil for a wide number of applications. BIO 30 leaves no carbon deposits and is highly resistant to oxidation. An outstandin
Electronics Forum | Tue Aug 23 14:23:18 EDT 2005 | Just a Viewer
Your machine manual should have a list of grease and oil... if not contact machine manufaturing for details.
Electronics Forum | Wed Feb 25 21:37:12 EST 2015 | dinhhuunam
Hi Bartel , 1.1 Profile Solution to Cold Soldering Cause for Cold soldering The peak temp of reflow is too low. The preheating temp is too high and it takes too long Solution Lower the preheating temp and increase the peak temp in the reflow zone
Electronics Forum | Wed Aug 30 07:18:27 EDT 2000 | russells
Can you use 96s solder wire on a pcb that has been plated with standard 60/40? if so what are the effects on the proerties of the 96s? If you cannot mix the two solders is there a more effective way than braid of removing the 60/40 from the plating?
