Electronics Forum | Thu Mar 24 12:59:14 EST 2005 | DasonC
Desicattor is used for storage and not the indicator or meter to check the humidity. I am not sure that the HIC will affect the solderability, if yes, when they pack together with the MSD then we also have solderability problem on component. Per J-
Electronics Forum | Mon Feb 05 12:57:35 EST 2007 | cyber_wolf
Take the nozzles out and let the indicator tip touch the metal face the nozzle pushes up into. This will tell you whether the variation is in the shaft or the nozzles. Also while your indicator is touching the holder, manually grab the shaft assy a
Electronics Forum | Tue Sep 04 14:02:35 EDT 2018 | elsabudz
Hi Peter, I read your concerns regarding IC parts not packaged with desiccants and thought you may find our new Type 2 Humidity Indicator card of interest. Please visit https://www.clariant.com/type-2-humidity-indicator-card Thanks, Elsa
Electronics Forum | Tue Apr 15 21:24:41 EDT 2008 | davef
We find it curious that: * Heat slug pad for Q19 didn't take solder, indicating a pad [board] solderability issue. * Signal termination pads for Q19 didn't flow well, indicating a poor thermal recipe or a pad [board] solderability issue. * Signal ter
Electronics Forum | Wed May 07 20:55:35 EDT 2003 | davef
Bollocks!!!! We are unfamiliar with the term overturn, but it can not be that uncommon. Our intial inclination is to barrel into this SMT Engineer's nap-zone and blast him, but it might not be a politic approach. So, maybe we'll temper the tack we
Electronics Forum | Fri Aug 06 11:07:49 EDT 2004 | JB
"I thought it was purely a mechanical up-down movement with the cam and hence the thickness hardly has any effect!" It is purely mechanical.On our high speed turret the machine knows the distance between the tip of the nozzle and the top surface of
Electronics Forum | Fri Apr 08 05:22:47 EDT 2005 | Bored
The light events are: Red - Alarm - Indicates that an alarm exists.This also occurs when the emergency power stop button has been used to stop the belt and turn off heater power. Orange - Alert - Indicates that an alert condition exists. Green - R
Electronics Forum | Thu Mar 20 07:58:12 EDT 2008 | cyber_wolf
#1Run a Fuji gold board and see if the problem persist. Is your board clamp slipping? Fid camera tight? etc.. To see if you have a Y axis positioning problem: 1.Put the machine in mecha check 2.Go into Y-axis 3.Place a dial indicator so that the st
Electronics Forum | Tue Jan 13 08:08:37 EST 2009 | leemeyer
I am assuming that the card that was changed was the motor driver card. Did they change the card with a known good board or just swap the X and Y cards. If they swapped cards it appears that the card that is now in the X motor slot is bad. Open the a
Electronics Forum | Mon Aug 31 19:15:36 EDT 2020 | dilogic
We have GSM2 with FlexJet heads (an older one). There are 7 sensor amplifiers (with LED indicators) for touchdown detection and one for z-safe detection which is of a different type (with numeric LED indicator). I can't find anywhere what the right n