Electronics Forum | Thu May 23 18:40:48 EDT 2013 | rway
I also agree. Even if it did meet specs, I wouldn't let a joint like this out. Reese
Electronics Forum | Mon Jul 16 15:44:27 EDT 2007 | davef
J-STD-001 doesn't necessarily require additional controls under conditions of low humidity, only that you verify the effectiveness of what you have in place. ESD S20.20 [1999] only says that relative humidity above 30% is "desirable". ESD S20.20 [200
Electronics Forum | Tue Jun 19 21:44:20 EDT 2007 | rfrog
The first thing that I would do is contact the smock manufacturer and ask them for advice on testing the smocks. ESD FROM A TO Z 2nd ed. (Kolyer) states that: smocks should have a resistivity of less than 10^12/sq and must not shed steel fibers.
Electronics Forum | Tue Jan 23 10:15:44 EST 2007 | slthomas
J-STD-001C just requires that the area not be so dirty as to contaminate your product, tools, workspace, etc. If you start counting particles, you're into cleanroom territory. Do a search on ISO 14644-1 for specifics. Actually Wikipedia does a ni
Electronics Forum | Tue Nov 25 17:43:09 EST 2003 | Gabriele
Try to see J-STD-001 Chapter 8.Cleaniness Requirements. Also you could info also on ASTM D5127-99. Rgds
Electronics Forum | Thu Sep 26 14:43:43 EDT 2002 | Jim M.
unsure of what solder spec. your working to?.IPC/EIA J-STD-001C, Section 9.2.4 clearly states dull, matte, gray or grainy appearing solders are accpetable depending on your process and if the acceptability of the neaxt paragraph is met.IPC 610 and J-
Electronics Forum | Wed Jun 12 11:11:50 EDT 2002 | davef
J-STD-001 guideline of 1000 lm/m^2 [93 fc] seems high, but it is the minimum level of illumination that operators and inspectors should have to perform their tasks. IESNA LPD Architectural Recommendations Type of Facility||General Area percent / fc
Electronics Forum | Wed Jan 12 10:05:20 EST 2005 | Dreamsniper
we are using polyimide boards 6 inches x 7 inches, 2.5mm thick, 12 to 14 layers, for aerospace industries. I am using a long bake of 12 hours at 70'C prior to manufacturing or exposure to elevated reflow and wave soldering temperature. If schedule i
Electronics Forum | Mon May 06 05:32:39 EDT 2013 | pavel_murtishev
Jim, Thank you for the input. Could you please check your standard filter pore size? A model number would be valuable. How many shop volumes (in cubic meters) do you pump per hour? Customer is seriously thinking over installing AC system similar to
Electronics Forum | Mon May 06 21:40:40 EDT 2013 | davef
ANSI/J-STD-001: * Temperature and Humidity: 18-30°C, 30-70%RH ** If out of range, shall verify electrostatic discharge control program according to ANSI/ESD S20-20 is adequate. ** For process control, more restrictive temperature and humidity limits
