Electronics Forum | Tue Nov 27 15:57:58 EST 2001 | mparker
rather than applying jumpers, try thinking it another way. Have all possible jumper connections pre-made by the fab design. Use an exacto or dremel to "open" the undesired paths by removing a bit of copper trace. total flexibility, only one fab make
Electronics Forum | Wed Feb 05 11:39:23 EST 2014 | escalador
Hi, I have an old GSM1 p&p machine unused for some time and I would like to know if someone can give me the correct jumper settings for the 3 Radisys UIMC axis control cards that go on slots 10,11 and 12.Someone modified card positions and I dont kno
Electronics Forum | Thu Oct 21 21:17:19 EDT 1999 | Jeff Ferry
Mark, A challenge for sure. I suggest you review two techniques for this type of rework\modification. The first method uses a special circuit track run out from under the BGA. See: Jumper Wires, BGA Components, Circuit, Track Method at http://www
Electronics Forum | Tue Oct 04 20:31:16 EDT 2016 | davef
IPC-7721, Section 6.1, Jumper Wires, Jumper Wire Selection #5 states: "Recommended wire is solid, insulated, plated copper wire, 22 to 32 AWG with a heat resistant insulation. Wire with tin-lead plating may be restricted due to environmental laws."
Electronics Forum | Tue May 02 19:29:03 EDT 2000 | Peter van den Berg
We're looking for a source of SMT links (Jumpers) 8mm - 10mm(.312in -.4in)long, capable of being placed by Panasonic MV2 series or MPA machines. Does anyone manufacture a feeder that creates links on demand?
Electronics Forum | Mon May 08 16:56:00 EDT 2000 | Peter van den Berg
Thanks Dave, we already use zero ohm resistors. What we're looking for is a flexible (bendable) jumper.
Electronics Forum | Wed Dec 10 11:54:15 EST 1997 | Kyle Dopp
I can remember seeing jumper wire that had special insulation that you melt to the board to hold it down instead of gluing. Does anyone use this product and can tell me where to get it.
Electronics Forum | Tue Jan 03 15:08:36 EST 2012 | joetest
I need a clean and simple-to-remove part that will temporarily connect one portion of a board to another portion .25" away. The ideal jumper wouldn't require desoldering or leaving parts behind, like a fuse holder. Is there such a thing?
Electronics Forum | Thu Feb 06 01:56:53 EST 2014 | aflex
Hey, First you need to check if the I/O port setting is ok. Also how many jumpers are you using? Atlast always connect JP4 to PLD registers base address
Electronics Forum | Tue Oct 06 20:18:27 EDT 2015 | edwaterfall01
With the address of FC107F24 I would look at the Slot 11 UIMC board. Try swapping with another Radisys Board. Check jumpers, changing one jumper only on each board.
