Electronics Forum | Tue Dec 19 10:08:10 EST 2006 | George
Grant, Why don't you try a water-base flux which is No-clean, VOC-free also? I have tried the 270WR flux from AIM with good results even on lead-free process. My $0.02, George
Electronics Forum | Mon Jun 26 23:33:20 EDT 2006 | KEN
We saw this condition over 3 years ago. It sometimes is called "champagne bubbles". The intemetalic formation is interrupted due to the micro voiding reducing mechanical strength. I discovered this on lead free test vehicles for a major computer
Electronics Forum | Thu May 30 10:31:03 EDT 2002 | robbied
Hi Yannick. This is an issue that we are just recently getting into but here is some ifo that I have gathered so far. I have seen/ used 2 different rework machines. The one we have bought is a 'PACE TF2000' which was at the lower cost end of the mar
Electronics Forum | Tue Jan 31 10:59:55 EST 2006 | carterhoward
Hi All, I�ve been doing some research on the issue of running lead-free solder paste and leaded solder paste through reflow at the same time. The point with this would be to process all standard leaded components with Lead paste while also processi
Electronics Forum | Wed Jul 07 14:32:24 EDT 2004 | Tom B
We have done the same using a Red Mask instead of Green. Its definitely a good idea. It makes it easier to distinguish lead-free from lead assemblies. However, unless you are totally lead-free or two processes are isolated, it will happen that you
Electronics Forum | Thu May 13 09:52:34 EDT 2021 | winston_one
Want to update this question a little, I know it appears few years ago, but I hope there is some updates... We have to assembly few samples of motherboards with this kind of finish (customer mistake during pcb order). Normally we can use leaded sold
Electronics Forum | Wed May 21 08:16:57 EDT 2008 | tonyamenson
Good morning gentlemen, I could use some advise as to the min / max windows for the wave process. We have had little problems with our leaded wave but when applying the same process to lead-free wave we are having problems. Obvisouly the temps are
Electronics Forum | Thu Jul 20 16:08:18 EDT 2000 | Grant Baynham
Do you have any experience with flip chip applications using lead-free solder, and specifically do you have any information revealing how the process parameters for standard air reflow atmosphere can be modified to match the results for solder reflow
Electronics Forum | Tue May 19 13:29:33 EDT 2015 | dyoungquist
We have been running a Heller 1707EXL for 8 years and added a Heller 1707MKIII about 1 years ago. We have not had any problems with either one of them. We do both lead and lead-free assemblies along with BGA/LGA components. If speed/volume is not
Electronics Forum | Tue Jan 13 22:07:42 EST 2004 | davef
No, there is no such information. Choices are: * Recognize that any voiding is a process indicator and that when observed, indicate a requirement for taking corrective steps. * Tell your quality people to quit looking at components other than BGA wi