Electronics Forum | Thu Sep 12 09:12:22 EDT 2002 | mhoughton
I have printed and placed similar devices in high volume with exactly this spec for a couple of years with no problems, are you using laser cut stencils and what type of solder paste are you using? and what is the end use of the product as it may nee
Electronics Forum | Thu Sep 12 09:15:29 EDT 2002 | mhoughton
I have printed and placed similar devices in high volume with exactly this spec for a couple of years with no problems, are you using laser cut stencils and what type of solder paste are you using? and what is the end use of the product as it may nee
Electronics Forum | Tue Feb 04 09:03:45 EST 2003 | Russ Roberts
Greetings, I am pretty new to SMT production, and have learned much from this forum. I am getting ready to build a CCA with many 0402 parts that are really close together. I consider these fine pitch. The board also has two QFPS, so my stencil design
Electronics Forum | Wed Feb 22 10:00:58 EST 2006 | dougs
We've just set up a couple of products with 0.5mm pitch uBGA devices on them, i went for 5thou thick, laser cut nickel (to aid paste release) square pads same size as the diameter of the uBGA pads. Or you could go to a 4 thou nickel stencil, better
Electronics Forum | Thu Sep 12 10:45:29 EDT 2002 | pbarton
We have used a laser cut stencil 0.15mm (0.006") thick with 0.3mm (0.012") square apertures radiused in the corners 0.06mm (0.0025") to aid paste release. This approach with the (type 3) paste we use has proven successful on thousands of devices plac
Electronics Forum | Wed Aug 25 17:09:53 EDT 1999 | Earl Moon
| | Does anyone have any information on stencil aperture/pad ratios for noclean solder paste. In the past I have experienced severe solder ball problems when using the same size apertures from aqueous products as I do with the No-clean products. Co
Electronics Forum | Wed Aug 25 15:51:58 EDT 1999 | JohnW
| Does anyone have any information on stencil aperture/pad ratios for noclean solder paste. In the past I have experienced severe solder ball problems when using the same size apertures from aqueous products as I do with the No-clean products. Cons
Electronics Forum | Wed May 22 13:40:24 EDT 2002 | Hussman69
Boy, I step out for a bit and everybody picks on me (just joking). I believe I may have been off base a bit. Checking every bit of your stencil design is very good - I do that too. I calculate LXWXH and reduce or over print where needed, depending
Electronics Forum | Thu Aug 26 04:35:54 EDT 1999 | Wolfgang Busko
| | | Does anyone have any information on stencil aperture/pad ratios for noclean solder paste. In the past I have experienced severe solder ball problems when using the same size apertures from aqueous products as I do with the No-clean products.
Electronics Forum | Fri Dec 17 15:26:48 EST 1999 | Victor Salazar
We use a homeplate design with 80% coverage on the tab, and 100% coverage on the leads 6mil stencil. All of our stencils are laser cut electropolished. We have had good success with this.
.gif)
