Electronics Forum | Wed May 19 20:11:21 EDT 2021 | compit
I have two machines - Emerald-X and Topaz-X. I cleaned (and changed Koganei electromagnets) only in Topaz-X - Emerald-X is in very good condition :) But my Emerald-X have SF (not FNC) heads. If head 1 is OK - change the relays with head 2 and check.
Electronics Forum | Fri Jun 28 03:04:21 EDT 2002 | Dreamsniper
Forgot to include the following: Dwell time is from 55 secs to 68 secs. Indium specs for the paste is maximum peak @ 228'C and 30 to 90 secs dwell time above 183'C. PCB is a 6 layer board with Dimension of 205 x 166 mm but is slightly dense with 11
Electronics Forum | Fri Jan 10 03:33:42 EST 2014 | hans88
hello people, we have a my12 wich has a problem it gives the following error during hardware initialization: F-MOT-MSETDYN Y/1236 :Motor amplifier channel a error. after this error it says hardware initialization failed. this prevents us of using
Electronics Forum | Mon Aug 31 15:21:04 EDT 2015 | zombee
Dear Users! I have a Topaz pick&place machine, but the conveyor motor is not working. 1st test - production: Start production in "operation" menu: if I put the PCB the entrace of machine, the assembly head-bank picks up the first 8 components (prec
Electronics Forum | Thu Nov 11 18:36:29 EST 2004 | valuems
Hello We have been working on the MPM's for over 11 years now. And we have never had any trouble with that circuit, just goes to show you. If you have one of the old, old manuals you will find a lot of errors. They corrected them as they went. We
Electronics Forum | Fri Jul 17 07:50:32 EDT 2009 | csm
Dear Jepoy We check the oilmatic system and I found a relay is not working, it will arrive until tomorrow. We still have 2 errors and 1 message, we are taking time because we don't have the Fuji CP6-4000 manuals or electric diagrams. we get this ma
Electronics Forum | Fri Jan 29 18:52:53 EST 2010 | cusackmusic
We bought an Ersa Hotflow 5 used a few years ago as a backup. Well, we needed a backup a few days ago, and it didn't back us up. When I turned it on, the screen on the machine is blank, and two buttons with an up and down arrow seem to turn on two
Electronics Forum | Mon Oct 13 15:33:36 EDT 2014 | rgduval
So...today, we were able to get rid of the z axis not mounted error. It looks like we did so by modifying the settings in axes location (matched them to the beam 1 settings). Now, when we try to lower the nozzles, we can hear a relay or switch clic
Electronics Forum | Tue Jan 05 17:32:51 EST 2016 | taiji
We have a TDK radial machine VC-7C, The "DNC CUT" button doesn't change state, the machine shows alarm "904 ALM CRD RX RECEIVE 800", We already check button and relay and working OK, Also check the cables and also OK. We have no idea where else to lo
Electronics Forum | Fri Oct 18 15:29:16 EDT 2019 | kylehunter
Hi all. We are currently trying to build a downstream bypass to have our final conveyor feed into our oven, which doesn't have a SMEMA interface. Right now we have to manually connect the two downstream ready pins by hand. I have a good idea of how I