Electronics Forum | Thu Aug 12 06:46:35 EDT 2021 | bukas
there is no, error $0022 in technical reference. is the error you are getting a EMER level? if so there is probably a safety sensor or switch that is causing this error. $0021 is related to door switch so I would go from there. do you have technical
Electronics Forum | Wed Aug 11 12:41:05 EDT 2021 | jamesatqkits
Hi Bukas, Thanks for getting back to me. What is the IF board? Is that the Interface Boards in the cage? How do I know if I have a healthy hard drive? Is there anything in particular to look for? I will run chkdsk today and see if it reports any
Electronics Forum | Thu Aug 12 12:50:14 EDT 2021 | jamesatqkits
Hi Bukas, Err 22 shows up on the Panasonic motor driver in the back. I purchased this machine used. I have never had it operating in my shop. I checked the output of the transformer, 110 V output is 97 220 is 197, so I checked my input its 200 (machi
Electronics Forum | Mon Aug 30 17:21:46 EDT 2021 | jamesatqkits
So it was the drive, I was able to swap the conveyor drive for the mirror drive, these 2 drives are the same luckily. Just tapping lightly on the head would cause a 22 error to appear on the drive, at first I thought the motor must be bad. After talk
Electronics Forum | Fri Sep 17 16:01:03 EDT 2021 | jamesatqkits
Hi Bukas, Do you have a CP45? I need some help: Ihave no board loaded, the machine is booted and homed. So to pick up a nozzle, I open the ANC window. Click on the nozzle I want, say 29 its a CN065 When I press pick, it asks, machine is not ho
Electronics Forum | Sat Jul 05 14:07:33 EDT 2008 | shellydhami
Main diffrences in failure modes for mechanically and thermally induced BGA solder joint fracture
Electronics Forum | Fri Oct 27 08:18:23 EDT 2023 | avaqsemi
what are the main differences tmc5160 vs tmc2209?
Electronics Forum | Thu Jul 10 22:44:54 EDT 2008 | davef
Too complicated to answer. Wudda you say that you post pix and we'll tell you what we think?
Electronics Forum | Fri Oct 27 21:39:48 EDT 2023 | sarason
Stepper motor drivers from Analog Devices? Send an email to Analog Devices and talk to a rep or go on the EEVBlog Forum and ask in https://www.eevblog.com/forum/beginners/ or https://www.eevblog.com/forum/projects/ regards sarason
Electronics Forum | Fri Feb 16 08:45:41 EST 2001 | davef
Why would one want to use a "new thread refresh" button? Isn't a new thread button refreshed, definition? ;-) Erzit possible that this is really two buttons? A "new thread" button and a "refresh" button? Could these two buttons be placed much clo
