Electronics Forum | Fri Sep 01 18:40:45 EDT 2000 | Daniel Szeto
Does anyone have experience on feeding BGA trays on Fuji IP2. Regards! D Szeto
Electronics Forum | Mon Jan 31 17:09:14 EST 2000 | John McMasters
I would assume the IP2 version is similar to the IP3. I've installed 2 of the IP3 ones and they work fine. The retro is pretty simple. Tape and reel is fine if you have the room on the MFU's, we didn't have that luxury though.
Electronics Forum | Thu Feb 03 13:49:42 EST 2005 | johnw
yip loads of times but to be fare it can happen with any feeder check the pb port tracks on the mfu sometimes the track shorts after a chip blows
Electronics Forum | Thu Feb 03 14:34:30 EST 2005 | jdengler
I had 1 of the feeder connectors on the MFU develope a short which blew 3 IC's before I found it. Good Luck Jerry
Electronics Forum | Fri May 27 08:55:45 EDT 2005 | cyber_wolf
Quick note on Hover Davis, I am not impressed with their Fuji IP feeders at all. They short out and blow IC's up in the MFU's They sell their own feeder set up stand to tell whether or not you have a shorted feeder. What the hell is up with that ?
Electronics Forum | Wed Dec 06 10:02:19 EST 2006 | cyber_wolf
Do IP1's use MFU's like the IP2's ? If so I can most likely tell you what the problem is.... Please advise.
Electronics Forum | Wed Dec 06 11:00:30 EST 2006 | jdengler
All of the IP-1's I have seen use a fixed feeder bank. No MFU's which is where the board is located for IP-II's. Jerry
Electronics Forum | Sat Feb 28 09:32:24 EST 2015 | assuredtech
That would be a mechanical adjustment however I would be a little suspect about why it is off and if you did your due diligence to isolate it.
Electronics Forum | Wed Feb 03 03:49:56 EST 2016 | webjelen
I have QP242E with two modules MFU-58. I need put tray unit STU1 to Modul2 but optimalization end with error. Module1 is alright. Setting Modul1 and Modul2 is same. Any advice ? Thanks
Electronics Forum | Tue Feb 24 15:32:10 EST 2015 | swiese242
Hi there. I have an IP3 machine that refuses to > power up the MFU cart on side 1. I have already > replaced the I/O card but still no dice. Is > there a relay or fuse that I need to check to get > this to power up? The machine will not operate