Electronics Forum | Mon May 06 16:34:20 EDT 2019 | tey422
First of all, I am not familiar with the machine you stated. But there is something you should check out. That is if the nozzle tips having solder paste stick to it or not. If nozzle tips having a fresh paste stick to it, the component might not a
Electronics Forum | Wed Apr 13 12:10:47 EDT 2022 | winston_one
Hello! We have a strange effect. Some pads of big trough-hole DDR slot just dessapear. Initialy it was soldered with selective soldering process (leaded, 290 degrees, ImSn finish, very short storage). Then some connectors with poor barrel fill we hav
Electronics Forum | Thu Jul 21 08:27:05 EDT 2005 | grantp
Hi, Yes, that's an idea, but from my experience with MYDATA, it would fail test, and the machine would either know it's lost the component, or it would not know, and the component would not be on the pad because the machine would think it's mounted
Electronics Forum | Tue Oct 09 14:59:52 EDT 2001 | slthomas
That's what we do with our MSHII's...setup one carriage offline while the other one runs. We also have setup carts to load the feeders ahead of time and haul them out to the lines. Of course, when we exceed the carriage capacity of 75 slots for an
Electronics Forum | Fri Oct 01 13:04:09 EDT 2004 | dorklover664
The company that I work for just bought two new Samsung pick and place machines (CP45FV). I love them. But we are having problems with the vibe stick feeders that we have. They have no groves or slots for the parts so if the tubs move at all the pla
Electronics Forum | Wed Apr 15 13:03:14 EDT 2009 | toddscherrsymcomcom
I am looking for any input on the linear stick feeder from Mydata. We currently use a vibe feeder and have a high number of miss picks/rejects on SO8 packages. Is the linear stick feeder worth the investment to upgrade from vibe?
Electronics Forum | Fri Oct 01 13:47:24 EDT 2004 | lgroves
Megan, Sounds like you are missing the adjustable guides on the vibe feeders- Please contact me directly so I can help you get them working correctly Larry
Electronics Forum | Tue Feb 06 18:46:13 EST 2007 | darby
Imagine you put two 8mm feeders on the rear feeder plate, they are about the same distance apart as the length of your tray. On top of these feeders are two slotted arms that allow you to move the arms towards the moveable rail. You place your tray o
Electronics Forum | Tue May 21 12:58:15 EDT 2013 | highmillr
We have 2-Samsung 431's followed by a 421 on our line..We run different revision boards with similar parts. Is there a way I can run one revision feeder set up.Then switch over to the next job without having to switch feeders around for the new progr
Electronics Forum | Wed Jan 06 14:34:20 EST 2010 | ppwlee
Hi, Has anyone have experience with manual soldering iron using automated wire feed? I am looking at poke yoke manual soldering 5 pins LCD and wondering if there are ways to control the volume of the solder applied to the board to minimize missing s
