Electronics Forum | Sat Jun 24 13:08:09 EDT 2023 | madisreivik
All is OK now. The machine was offline couple months and probably some memory battery is dead. All problems were solved after uploading prop data to IP and MTU.
Electronics Forum | Fri Dec 21 09:40:40 EST 2018 | kdexter0928
I am at wits end with this machine. The MTU on my IP2 will not zero set. It gives me a few different errors depending on its mood. I receive MTU T- OT, MTU X- OT, or MTU Y- OT. when the machine attempts to zero set it travels until it OTs. I have tri
Electronics Forum | Fri Oct 15 16:52:52 EDT 2010 | wingding
Fuji IP2: I am having problems with an MTU Cycle Alarm error. There is no such error listed in the IP2 manual or the MTU manual. It sometimes comes up while placing parts on a board or sometimes right after Zero Set. Does anyone know what generates t
Electronics Forum | Wed Jan 02 12:03:13 EST 2019 | jdengler
They go through TN-3 to get to the TSA-200A D/A module. This is all in the MTU. It's been a long time since I worked on an IP-2 but see if you can get to the I/O screen for the MTU. Have someone flag the in range sensor and see if the input status on
Electronics Forum | Thu Oct 13 14:09:44 EDT 2005 | rcanten
If there is no option to send the proper data to the MTU it sounds like your line editor is configured incorrectly. You will still be able to send programs and the such but like you said you would never notice it until you had to send the proper back
Electronics Forum | Fri Jun 23 21:10:29 EDT 2023 | meher
To resolve this issue, you need to ensure that the proper data is stored and transmitted to the MTU. Double-check the communication settings between the machine and the MTU during the startup process. Make sure that all the necessary data is being se
Electronics Forum | Fri Sep 16 08:36:45 EDT 2005 | ajay
check some relay might be bad on MTU. we faced similar problem in IP3.
Electronics Forum | Sun Dec 30 22:58:00 EST 2018 | assuredtech
DEX, The MTU has it's own proper and status separate of the IP2, are you sending both? Ed
Electronics Forum | Wed Jan 02 09:18:48 EST 2019 | kdexter0928
As far as I can tell In the software I am using it has them combined. I am using ProSMT+. I don't see any option to send a separate proper for the MTU alone. Am I missing something?
Electronics Forum | Wed Jan 02 09:28:56 EST 2019 | kdexter0928
Would I need to have the mtu in in the line as a separate machine? you know how good ol' ProSMT is, nothing seems to work how it should.