Electronics Forum | Wed Jul 17 02:31:30 EDT 2019 | mk15
I am looking for some help for where to look to fix this MY15E problem.After hardware initiation appear F-MOT-MSETDYN conveyor transport/1250: amplifier DC-link too high.Any suggestions? Thanks
Electronics Forum | Wed Jun 16 21:34:28 EDT 2021 | damiendigilin
Hi Does anyone know how to fix Z Axis Zero Point Unstable on My Data MY15. The machine will pick 3 components then error Z zero point unstable. We have changed the Z sensor the Z DC Motor the Z positioning encoder. Thank you
Electronics Forum | Thu Jun 03 13:11:02 EDT 2004 | Scott B
We had an existing Mydata MY15 line and inherited 2 Quad lines (QSP2 and QSX1). We eventually had to get rid of the 2 Quads (major software and hardware issues) and have replaced these two machines with an addition single Mydata MY15 and are getting
Electronics Forum | Fri Nov 22 00:09:29 EST 2019 | mk15
I am looking for some help for where to look to fix this MY15E problem. 1. after hardware initiation appear - F-MOT-MOVE X/250: Motor speed out of control (photo1). 2. in service mode when x motor initiate appear - F-MOT-MSETDYN X/12: No axis movemen
Electronics Forum | Mon Nov 25 10:57:31 EST 2019 | rgduval
You should be able to see the counts in the service screen for the motors while testing them...that's usually the easiest way to see if they're functioning...at least the encoders. In some of the older systems, the drive motors were all the same, an
Electronics Forum | Tue Aug 25 01:33:00 EDT 2009 | hurr
Hi Jack, we have in our comapany My15 and MY9. Both machines we programming almost daily only in excell. First manually, second with excell macro. Both alternative are almost camparable. It´s depending on amount of SMD parts and skills. Radek
Electronics Forum | Tue May 31 01:56:25 EDT 2005 | grantp
Hi, We run both, and the Fuji's have a much better vision system, and will place reliably. I would never recommend MYDATA over Fuji, as there is a huge difference in stability and placement accuracy. Regards, Grant
Electronics Forum | Tue Jun 12 14:28:17 EDT 2012 | dontfeedphils
It should be pretty straight forward while taking it apart, just make sure you label things, and be ready to run through every one of the calibrations after it's put back together. Oh, and have fun Bill!
Electronics Forum | Fri Oct 12 11:16:46 EDT 2018 | tech1
Sounds like one of the Z stops is not functioning or needs to be adjusted.
Electronics Forum | Mon Nov 25 02:15:07 EST 2019 | mk15
it is possible to test x belt motor and x wagon motor.
