Electronics Forum | Mon Oct 17 13:58:09 EDT 2022 | cyber_wolf
I would say not very reliable. The component separator spring, pick point adjustment, and magazine have to be perfect. Your nozzles have to be perfect etc..etc... My general advice is move to a different platform if possible. I have worked extensive
Electronics Forum | Tue Oct 25 00:32:32 EDT 2022 | alexvolovich
> How reliable are TM feeders for 0402 placements? > I have a board with 2000+ 0402s that I need to > run daily. I don't need agilis feeders for > change overs as we use less than 50 feeders > total. Standard TM8 magazines will
Electronics Forum | Wed Jun 08 20:16:42 EDT 2005 | Grant
Hi, Sorry for getting a little off the original thread topic here, and we should do this offline. We found there is quite a difference running a few boards to running hundreds per day with about 100,000 placements per day. That's what we ended up d
Electronics Forum | Fri Jul 13 14:06:34 EDT 2007 | fredericksr
explaining the problem in full each time -> miscommunication/misunderstanding and disagreement). Additionally, I have not, until recently, admitted to tech support that we had modified our centering jaws. I have uncovered evidence that a slight m
Electronics Forum | Tue May 01 13:25:20 EDT 2001 | kaoni
Thank you Wolfgang, My time table is the amount of time it takes to get it right. I hope to have product by next December if possible. Yes, I am starting from ground zero. I need to go 201 because of the size limitations as to what I need to fit in