Electronics Forum | Fri Jan 19 05:46:59 EST 2018 | ivammendes
MYDATA MY9E: Hydra's pipe can't stop the vacuum during assembly. The problem ocurre just in only one pipe, the number 5. The tool picks components but doesn't drop it. Can the problem be in the unit vacuum?
Electronics Forum | Thu Mar 28 18:00:31 EDT 2024 | alexv
The tapping noise is what you hear when Hydra taps each tool on the tool bank to make sure the tips are seated well. The error is a Z-motor problem. The gear is at the top of the Hydra and needs grease. Have you cleaned the old grease and applied new
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Fri Feb 21 10:50:00 EST 2020 | tomdegas
I am getting the following error on our MY9 during hardware initialization: F-MOT-MSEDYN HYDRA Z/156 Motor Timeout After the Theta test, The HYDRA head moves slowly all the way to the bottom and then moves slowly back up and the system fails initia
Electronics Forum | Thu Mar 05 07:40:55 EST 2020 | tomdegas
I swapped the mi boards with ones from a working My12 machine and the same results. To recap my problem: On "Hardware Initialization" the center jaws open and close, the Hydra Theta belt moves back and forth, the Hydra head moves all the way down an
Electronics Forum | Wed Sep 21 12:12:24 EDT 2005 | vikkaraja
HI there, I have a problem with my TP11 HYDRA HEAD. It is not picking up parts from the magazine. I have been working with Mydata on this issue, but I have not had much success so far. So far I done the followings:ran vaccum test, tube height, and H
Electronics Forum | Tue Nov 15 23:03:07 EST 2011 | supse
Hi I have a problem with one of our MY12 machines, the machine stops very often (approx. 10-20 times a day) writing the following error message : f-mot-msetdyn hydra theta/205(f-hrdw-3). We then have to reinitialize the machine to continue productio
Electronics Forum | Mon Jun 15 17:54:38 EDT 2015 | catsem23
Hi I have been having a problem with my Hydra tool reference plate. Machine keeps stopping and comes up with error message - failed to locate hydra tool reference marks & Error mounting component .... from feeder ..... with nozzle .... I have check
Electronics Forum | Tue Jan 11 03:43:51 EST 2005 | Scott B
We have had similar problems and have abandoned use of MySpeed. I don't know what version of Mydata software you are running but have started to use the 'Hydra Preparation' function within TpSys 2.3 to arrive at optimised set-ups. Mydata advise that
Electronics Forum | Wed Nov 16 18:20:39 EST 2011 | dontfeedphils
According to the message guide it just says that it's a error telling you to initiate the Hydra Theta axis. I suppose the encoder for the hydra theta motor could be losing count and causing it to need to be re-initiated, or it could be something to