Electronics Forum | Mon Apr 08 14:16:29 EDT 2019 | sever_83
We've never heard of seen of such a thing either. We tried a clean sample board and applied con coat. Same process through out and we saw nothing. After speaking with the original operators who was curing the boards he had left the boards much longer
Electronics Forum | Thu Apr 21 11:43:03 EDT 2005 | davef
We understand the problem of trying to coat over RTV. We have seen the same problem with acrylic and urethane coatings not wanting to stick to RTV. Some acrylics seem to be worse than urethane. Since this is a new product, may be you could pot your
Electronics Forum | Wed Oct 27 13:20:47 EDT 2004 | DavidB
We are producing boards with Alpha 591S RMA No-Clean paste and are coating after SMC with Dow silicone ( toluene solvent based) conformal coating. We have experienced several failures due to soft shorts ( electrochemical migration?) We have also obse
Electronics Forum | Thu Jan 04 17:26:17 EST 2001 | Cory
We're going to begin conformal coating a few of our assemblies as required by our customer. We're using Kester No clean paste and will use cotton gloves to keep the boards clean while handling. My question is: Do we need to clean the boards prior to
Electronics Forum | Fri Jan 26 13:26:30 EST 2007 | rw
We are developing a new product that requires conformal coating on the motor controller. We selected a silicone based conformal coat due to its ease of use. There has been disagreement among engineers as to its impact on the motor. We have contact
Electronics Forum | Mon Jan 29 20:25:24 EST 2007 | davef
We allow no silicone in our shop, because they ruin solderability.
Electronics Forum | Thu Feb 01 09:46:54 EST 2007 | blnorman
Especially VCM - volatile condensable materials. Strictly verboten around optics.
Electronics Forum | Wed Jan 31 17:01:34 EST 2007 | rw
I'm not that concerned about the solderability of the motor. Our customer is concerned about the outgassing of the conformal coat effecting the motor brushes. Silicone will break down into SiO2 and SiC will result from a spark between the brushes a
Electronics Forum | Tue May 23 15:40:17 EDT 2000 | larry
We currently use both Humiseal and Conap with OA flux. The flux MUST me cleaned off the assembly before coating. I know that Humiseal has coatings that are compatiable with no cleans as long as your processes are defined properly before your coating
Electronics Forum | Tue Jan 30 18:34:56 EST 2007 | realchunks
Hose and/or Dave, Please elaborate of how the silicone can affect soldering. Material itself or fumes?