Electronics Forum | Mon Mar 13 05:29:08 EST 2006 | hitechsc
Hi just to clear a few things, We produce the nozzles and the parts are manufactured in two stages, CIM and plastic injection moulded, we designed the rear end of the ceramic tip with spikes so when the secondary operation on plastic over mould the p
Electronics Forum | Tue Nov 08 20:20:32 EST 2005 | davef
Necessary tools are: * Chisel * Ball peen hammer After you buy two new nozzles, keep one in a baby food jar filled with your underfill suppliers recommended solvent for half the shift. At the break, swap the dirty nozzle on the machine with the cle
Electronics Forum | Sun Feb 23 14:51:02 EST 2003 | davef
Without being clear on whether you're talking about: * Standard air knives at the back-end of your in-line cleaner ... OR * Hand held or similar nozzle. Standard air knives: This causes no problem with ESD because the relative humidity is so high t
Electronics Forum | Wed Sep 20 10:05:10 EDT 2006 | SWAG
Not familiar with 3C/4C but if the head is similar design to Samsung then you might consider flushing the tubes and airlines that go to the nozzles. We used to disconnect the airlines at the top and run cleaner down through the tubes. We would then
Electronics Forum | Tue Feb 15 19:24:28 EST 2005 | Alan
I have also seen this before on a CP6. We had an issue once on a CP where the shaft was coming down too far at stn 1 for pick up and forcing the nozzles up and sticking in the windmill. Check that the correct spring type is being used. Also, maybe
Electronics Forum | Mon Feb 23 07:09:28 EST 2004 | Erv
We have been using the 3M Electronic Service Vacuum Cleaner for a couple of years. The buisness end (hose and nozzles) is ESD Safe, it's Easy to use, and filters are a snap to change. The case is not ESD Safe, but if you do not set it on or right nex
Electronics Forum | Thu Jun 24 19:14:44 EDT 1999 | Mike Konrad
Very good questions Bob� Given the fact that my company is a manufacturer of batch cleaning equipment, I will speak more in general terms rather than in specific terms. There are several criteria used in the evaluation of batch aqueous cleaning sys
Electronics Forum | Wed Nov 08 10:04:56 EST 2017 | swag
s100 total cycle cleaner works good.
Electronics Forum | Thu Feb 09 09:18:22 EST 2012 | swag
I'm not familiar with Quad but I have had very similar problems on printers. If your conveyor has an L-bracket over the top of the conveyor belt to keep it down + aligned, you might need to remove it for cleaning or make some adjustments to it so it
Electronics Forum | Sat Aug 18 22:43:14 EDT 2012 | eadthem
we service all of our lightning spindles once a year, Take the spinldes off. loosen the screw by the nylon cap and slide the locking pin out. run the spindle shaft, the nylon cap and pin assembly , and spring thrue a ultrasonic cleaner with 99% is