Electronics Forum | Thu Jan 13 09:55:44 EST 2005 | fasst1
Rob, I actually work for Philips / Assembleon. We have had machines out in the field for 18+ years that are still in production. The customer I mentioned has had the gear for 4 years. They also do multiple changeovers every day, and each one take
Electronics Forum | Mon Feb 18 09:46:42 EST 2019 | cdav1100
We currently run a Yes Tech BX machine using the Yes Vision software on Windows 7. With Windows 7 support running out in January next year, I was curious if anyone had managed to run the Yes Vision software under Windows 10. The obvious answer is to
Electronics Forum | Sun Feb 24 13:52:47 EST 2002 | bentzen
Hi Armin Printing equipment can be divided into two main groups; In-line and off-line. For "small" production sites an off-line screen printer should be adequate but for high out-put placement lines, where the product cycle-time is short, an in-line
Electronics Forum | Sun Jul 28 23:11:52 EDT 2002 | caldon
Sam - If I owned Cal Driscoll Electronics and were looking for a rework system a few things I would consider: 1) Convection is key (IR as an under heater or pre heat is ok but not as the main heat source). 2)programming simple? User Friendly and easy
Electronics Forum | Mon Apr 11 08:47:34 EDT 2005 | Rob
There's not many ways of doing it on the cheap except... Buy a second hand universal GSM1 with VME 630 vision, 0.5 mil per pixel camera & some expensive ceramic nozzles for the 0201's. This will be quite slow & the software quite awkward but lookin
Electronics Forum | Fri Dec 17 16:07:07 EST 1999 | Alex B
Hi, C.K. Let's assume that your stencil's thickness is in a range 4-6 mil or by other words the height of the solder paste on a pads is the same (close enough to reality) Therefore, for pad's width more than 20 mils(as well as pitch between pads) th
Electronics Forum | Tue Nov 29 16:30:05 EST 2005 | russ
We have utilized one of these for about 6mos. now (is that right Larry? I know you're reading this.) So far it has proven to be a very good machine. Getting the vision right on chip caps can be tricky and sometimes frustrating but once they are rig
Electronics Forum | Mon Sep 20 15:32:27 EDT 2010 | naveed
Yes!tahnkx I made a backup disc.the all data for production files,and also the data base library(vision files for component and fiducials) has been copied to the disc.we are in contact with yamaha consultant,they sent us the new manual which has the
Electronics Forum | Thu Jan 05 12:33:30 EST 2017 | rgduval
If you haven't resolved this yet, I think you're going to want to go to either the part or the package (I'm not sure which one off hand), and make sure that the hydra heads/tools are selected for placement. You'll also want the vision set to the lin
Electronics Forum | Wed Sep 19 15:32:24 EDT 2001 | jschake
I�ll volunteer to answer this one for Jake. In order to prove the performance and capability of the stencil printing process, I think this level of inspection detail is required. However, in a production scenario where a known printing performance
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723