Electronics Forum | Thu Dec 21 10:46:17 EST 2006 | Brandon
1998
Electronics Forum | Thu Dec 21 14:07:47 EST 2006 | realchunks
Sent
Electronics Forum | Thu Dec 21 09:32:35 EST 2006 | Brandon
Does anyone know of a source other than speedline? I know these can be had for $100. Speedline wants $1600. It is a cooling zone blower motor for a cross blow system. Not the same blower you see on the top of the heating zones. This one mounts from t
Electronics Forum | Wed Jan 17 21:02:48 EST 2007 | Jnet
If you are just wanting a replacement blower for your air crossflow cooling section. You should be able to purchase through Electrovert cheaper than $1600 dollars. Someone must have quoted you more than just a replacement blower.
Electronics Forum | Fri Dec 22 05:48:29 EST 2006 | maxinorper
Hi, We have refurbished blowers. Cleaned them, changed bearings, capacitor. These parts are standard parts, you will find them in "any" hardware store and Radio Shack type dealers.
Electronics Forum | Thu Dec 21 11:58:07 EST 2006 | Brandon
Can you send a digital pic to bgoodwin@pentechassembly.com please? Does it turn clockwise when powered on?
Electronics Forum | Mon Sep 01 04:55:20 EDT 2008 | benefon
Hello all Our Omni 5 has given the 'Cooling module high temp' warning twice during the past month. I suspect that the blower motor is the culprit but have not been able to verify this because the oven has started up normally after acknowledging the
Electronics Forum | Wed Sep 03 07:39:19 EDT 2008 | pjc
You may not be getting enough exhaust pull, so the cooling modules over temp. Try swapping blower motors to isolate that before buying one. STANDARD AIR OPERATION: - Load-end: 150 cfm (255 m3/hr) at the 4� (102 mm) stack (minimum requirement) - Unlo
Electronics Forum | Sun Sep 13 18:45:24 EDT 2009 | halleyjoan
Is there any possible way to repair the blower of vitronics reflow oven if it stuckup? How to replace its blower? Or i should be replaced as 1 assembly (cell motor and blower assembly).
Electronics Forum | Wed Jul 11 13:29:17 EDT 2007 | cyber_wolf
Hi, We recently purchased an XPM1. It has 3 squealing blower motors. Of course they are the ones on the bottom zones. I have read the procedure in the tech manual. Does anyone have any experience replacing these blowers? Can you offer me any helpf