Electronics Forum | Mon Sep 27 08:52:11 EDT 1999 | Brian
| i had a problem here, during the wave soldering process, we apply a water soluble mask on the gold finger to protect it from contamination. But after washing, there is still some mask left on the gold finger. | Can anyone pls advise is there any pa
Electronics Forum | Thu May 27 08:04:15 EDT 2004 | davef
Contact the licensers of imm silver process, mentioned earlier in this thread.
Electronics Forum | Tue Aug 09 11:56:01 EDT 2005 | Rob
We sometimes use a peelable mask the the PCB manufacturer (board house) adds as part of their process. It may seem an expensive option but avoids: Raising P/o's for tape/peelable mask as consumables booking & inspection Booking out to the shop floo
Electronics Forum | Wed May 26 06:59:10 EDT 2004 | davef
Some peelable solder masks attack immersion finishes. It appears components in the peelable soldermask, such as ammonia, are not very friendly to these particular surface finish. [We've wanted to investigate the effect of mask application thickness
Electronics Forum | Mon May 22 17:14:16 EDT 2000 | Justin Medernach
Hi All, I'm looking for companies who sell in-line solder mask applicators capable of dispensing peelable as well as water soluble mask formulations. Could anyone provide me with some names, please. If this is the wrong forum for this question, I d
Electronics Forum | Thu May 27 06:47:45 EDT 2004 | Bryan Sherh
Hello All, I 'd like to have some stuffs about immersion Silver to study with.Can anybody provide some information or some articles about Immersion silver? Thanks a lot. Bryan
Electronics Forum | Thu May 27 06:48:20 EDT 2004 | Bryan Sherh
Hello All, I 'd like to have some stuffs about immersion Silver to study with.Can anybody provide some information or some articles about Immersion silver? Thanks a lot. Bryan Bryan.she@163.com
Electronics Forum | Sun May 30 01:17:02 EDT 2004 | johnwnz
Hmm, the type of thing you'd expect the PCB vendor to warn you about or test prior to changing their process!.. fun & games. So are they good donuts?
Electronics Forum | Wed May 26 03:04:09 EDT 2004 | johnwnz
Mark, that would be a good report to have a look at can you post it on the site or mail it out to me? Also I've been having an issue with blue peelable solder mask on silver boards where it peels the silver off with it. I've only seen this since my v
Electronics Forum | Mon May 31 04:06:16 EDT 2004 | johnwnz
You know you'd think that wouldn't you but the only tiem I knew the vendor had changed something was when the silver started to fall off the boards!... you can tell I wasn't chuffed Now I have to say I do prefer Dunkin's to Krispy but I can't say I'