Electronics Forum | Wed Dec 14 15:49:30 EST 2005 | derengmao
I did calibration for the fixed camera according to the Training Center System's book. But it seemed it is for diciding the heads'offset, very few is for camera itself. When calibrate, It does recognize the calibration tool ad finish. However when te
Electronics Forum | Mon Dec 12 14:05:45 EST 2005 | derengmao
I tried to use the Fixed Camera to inspect TSOP, however, I got either "UPPER SIDE END PIN ERROR", or "Missing Group:1". I have never had a parts getting recognized. I adjusted all parameter possible: Light, size, width, length. By using Dispaly Par
Electronics Forum | Sun Mar 12 22:02:40 EST 2006 | Steveo
Personally I think Grid lok is inferior to the new Vacunest system, especially in screen printing. Vacunest is basically a bean bag that conforms to the shape of the PCB and then holds this shape indefinatley under vacuum, until the vacuum is releas
Electronics Forum | Tue Feb 21 10:45:45 EST 2012 | acsscott
Thanks for the password. There is a 7 pin connector for the Emergency stop in and out. It has a mate with a jumper wire attached to the Topaz end. If you put the jumpered mating connector on this, the emergency stop errors go away. The other conn
Electronics Forum | Wed Jul 14 17:33:04 EDT 2004 | Ross Clunie
The short answer is "No" the white and green feeders are not interchangble. The green feeder has a channel in it to allow the "embosed" or plastic tape to fit flat at the pickup position. If you use paper tape in this type of feeder the tape can be d
Electronics Forum | Sun Mar 29 13:49:59 EDT 2009 | tpappano
Hi Peter, I'm a new user of a CSM84VZ, so I have only a small grasp so far about what goes on in the machine 8-) There should be two locating pins. One fixed and the other adjustable for different board widths. Small cylinders are coupled to the
Electronics Forum | Fri Jun 04 02:51:25 EDT 2010 | tomta
We have a DEK 265 printer currently down due to the rail system error. The message "Belt Motor Error. Rail lifted error, check tooling" pop-up when pressed run. I did remove all the support pins prior loading a new job. I also ran rail system dian
Electronics Forum | Wed Feb 14 15:24:24 EST 2018 | cbart
I assume you verified the pin support table was not actually stuck or still in the up position?
Electronics Forum | Thu Jul 09 13:19:38 EDT 2009 | emanuel
Just in case somebody will bump in the same situation and looks for a possible solution, the problem was with a small 2 pin connector that feeds one of the W DC motors. The connector looked ok, but one of the pins pulled a little out and was making
Electronics Forum | Wed Jun 21 09:23:28 EDT 2006 | rmitchell
problem solved. Some PCB table support pins were jammed down in the table preventing the Z axis from lowering all the way. The intial error mesage was x and y servo, but the real error was the z axis overflow. Rob
