Electronics Forum | Thu May 21 18:11:37 EDT 2020 | gabriel1blue
Thank you for your reply. I tried to contact Panasonic support but even them have a hard time getting information on this machines. I have been waiting for them to let me know if they help us but no luck yet. I did replaced the a few backup batteries
Electronics Forum | Tue May 15 21:57:06 EDT 2001 | davef
Welcome!!! Where the hay ya been??? Sorry bud, were lining-up with your fab [it hurts me to say that, but when yer ] We used to dry pack with desiccants, also. Its probably an old MIL-STD-2073-1C requirement [er something like that]. We qui
Electronics Forum | Mon Jul 19 11:11:18 EDT 1999 | Wolfgang Busko
| Perhaps a little hard to find but is there anyone who uses a vapor phase process to solder populated card with BGAs. I am interested in the success rate of such a process. It is obvious that the throughput is reduce vs a convection oven but still t
Electronics Forum | Fri Sep 09 06:08:39 EDT 2005 | geb
I think it may be the card thats causing the problem. When both machines are set to display a live image, the faulty machine shows pink/red. When their cables are pulled out of the card the working machine shows grey/noise and the faulty machine stay
Electronics Forum | Mon Nov 29 13:01:35 EST 2004 | bobsavenger
I have a DEK 265LT screen printer and a Fuji bare board loader. I cannot get the two machines to talk through the SMEMA cable. I have the personality card for the DEK and I have the correct cable for a FUJI machine. Is there something that I nee
Electronics Forum | Thu Sep 08 11:56:37 EDT 2005 | siverts
I have seen this before. Sounds like that You are having problem with the vision box, located in the rear left of the machine; that is if you are using the old vision system, the newer Lantern vision card is located in the VME chassi in lower front r
Electronics Forum | Fri Mar 07 13:04:45 EST 2003 | gdstanton
Anyone out there have a source of information on the type of terms and conditions a subcontractor may use for a printed circuit card Build-to-Print job?
Electronics Forum | Thu Mar 13 11:19:11 EST 2003 | gdstanton
Company B would be buying material (components and bare PWB) and fully assembling the cards for Company A.
Electronics Forum | Fri Sep 09 03:51:57 EDT 2005 | geb
Thanks for your help. Yes it is a VME630 Lantern vision system. I'll try swapping the card with the one in the other machine.
Electronics Forum | Fri Oct 28 02:18:03 EDT 2022 | kamedatec
I bought a YV100XG machine with AutoTC (Automatic Tray Feeder), Everything is working except AutoTC, when I active this function, pops up the error that the Servo Motor LZ1 was not found. I changed the control card of the servo motor, checked the wir
