Electronics Forum | Fri Jul 27 13:51:53 EDT 2018 | vlad_saviuk
Hi, have some question: during solder paste printing I'm faced with problems on the edge of the PCB - solder balls on gold pads. During analisys we checked everything - change squeegee preasure, different cleaning cycles, squeegee speed - no effect.
Electronics Forum | Tue Nov 03 20:00:47 EST 2009 | davef
Solder Mask Adhesion Pull Test Tape List IPC-TM-650 Test Method 2.4.28.1, Adhesion, Solder Resist (Mask), Tape Test Method, defines the procedure for determining the adhesion of solder resists (masks) used over melting metals, (such as solder plated
Electronics Forum | Sat Nov 22 09:51:51 EST 2008 | realchunks
You need to take it a few steps farther. The main reason you would want to reject a certain % off print is because it made defects. So you need to see how far you can go without creating a defect and then establish that as your cut off and the need
Electronics Forum | Wed Apr 27 11:43:32 EDT 2005 | patrickbruneel
Hi Daan, What we did in the time was pareto analyses on all board designs to determine the critical areas (mainly design errors) and only inspect those specific problem areas. Every batch had a copy of the PC board with problem areas marked and only
Electronics Forum | Wed Mar 16 09:06:07 EST 2005 | russ
This is what I might do, I would purchase either a solder volume (preferred) or at the least a paste height measurement piece of equipmment, The most important parameters with pronting are volume and registration. You need one of these inspection
Electronics Forum | Wed Sep 22 21:23:03 EDT 1999 | se
| | I've had some trouble pasting a test board for a MicroBGA trial. Most of the paste remains in the stencil apertures. | | The stencil is 6 mil thick, laser cut and electo-polished. | | The apertures are 12 mil in diameter with 20 mil pitch. | | We
Electronics Forum | Thu Sep 23 12:47:48 EDT 1999 | Earl Moon
| | | I've had some trouble pasting a test board for a MicroBGA trial. Most of the paste remains in the stencil apertures. | | | The stencil is 6 mil thick, laser cut and electo-polished. | | | The apertures are 12 mil in diameter with 20 mil pitch.
Electronics Forum | Thu Mar 20 20:57:44 EDT 2008 | rrpowers
Well, we are in fact doing a no-clean, multi-shift, very high volume, minimal changeover operation. We use up any paste long before it gets old. Because of the sheer volume any reduction in paste scrap for us is big money. We also are in a zero de
Electronics Forum | Wed Sep 06 18:19:37 EDT 2017 | slthomas
Hi All, We are being intermittently challenged by a .5mm pitch uBGA paste release issue. We don't build with many of these so don't have a lot of history here. We've gone through 3 different stencil designs and the most consistent performer was 4 m
Electronics Forum | Sun Jul 26 07:52:35 EDT 2020 | sync40
Hello to everyone, Have you ever experienced soldermask bubbles inmediately after printed the soldermask itself? (for screen printing method of LPISM). I am not talking here about blistering or any outgassing defects after exposing to high temperatu
