Electronics Forum | Tue Sep 25 05:58:16 EDT 2012 | bobpan
I believe the Led's should flash 3 times when the card is booting up/ powering up normally. There was no board troubleshooting back in the day and we just replaced the card. Make sure the metal cover is grounded to the machine.....this sometimes caus
Electronics Forum | Tue May 07 13:22:11 EDT 2013 | ngineer
Yeah, it comes on for a couple of seconds, then trips. When it comes on, before it trips, i can look into where the axis drives are, and the z-axis has a red and green led lit, while the others only have a green one. Then it trips. Maybe that drive
Electronics Forum | Thu Aug 29 05:01:38 EDT 2013 | bobpan
Motor Error 5 is usually an interlock error. Take off the rear right cover and look at the red and green led's on the driver cards. If they are both lit....you have a door open or if you have carts....a feeder base switch is up. Good Luck
Electronics Forum | Thu Aug 29 14:20:17 EDT 2013 | nophsem
Thanks for the response bobpan! LED's on the driver cards work well (green with doors closed and both red&green on with door open), and I don't use the carts. The head doesn't move after power on and inmediately you can listen alarm.
Electronics Forum | Mon Jun 16 11:36:28 EDT 2014 | bobpan
Are both red and green leds on for the driver cards (they are located in the bottom right of the machine). If they are both on then you have an interlock opened. If this is the case....check the side doors....sometimes they are not shut all the way.
Electronics Forum | Tue May 17 11:12:09 EDT 2016 | bobpan
Press both buttons simultaneously. Press black button 3 times. Led will flash then go solid. This will toggle the pitch between 2mm and 4mm. have fun.
Electronics Forum | Tue Oct 09 10:52:57 EDT 2018 | bobpan
re-adjust them .....yes just bend them in a little more. As for led's ....i have tried all kinds...some work better than others.
Electronics Forum | Mon Feb 08 12:18:40 EST 2021 | mendez
The mylar is just the keyboard and has its own connector. All the keys seems to work well (the lcd pcb has some leds and they blink when I push each key). The lcd is soldered on the display board.
Electronics Forum | Wed Jul 08 23:07:18 EDT 2020 | tylerrobertson
Hello, Trying to re-purpose a QUAD feeder for delivering small parts to a scada robot. Wondering if someone could help me out with a pinout for the connector. it's 8 pins Feeder is p/n 12/10-23959B SSA Was able to get the board to power up and flas
Electronics Forum | Thu Aug 08 11:04:48 EDT 2019 | btfonseca
Hi everyone, I was recently trying to troubleshoot a bad floppy driver on our QSV-1, which actually worked, I was able to read floppy drives but for some reason it all went downhill when one of the green LED's turned off and another red LED turned on