Electronics Forum | Tue Mar 30 17:52:15 EDT 2010 | cusackmusic
They are very finiky. If you have good solder paste, and a slight down pressure, to make sure the LED is "stuck" to the board, you should be able to place it. Pick it up on the center of the flat, NOT the lens. Even with the vacuum turned off, t
Electronics Forum | Wed May 11 15:04:16 EDT 2011 | thejedeye
LED sticking in nozzles are such a problem, seem everyone has issues with this from time to time. Don't want to advertise who's nozzles worked best but will answer you back if you drop me an email.
Electronics Forum | Wed Mar 31 10:55:42 EDT 2010 | fredc
I worked on a nozzle for one of these LEDs in the past. I seem to remember that there are raised surfaces outside the pick up area. Be sure your nozzle is not hitting them, if so you will lose vacuum. A rectangle shaped nozzle would maximize your abi