Electronics Forum | Mon Apr 02 09:57:17 EDT 2018 | vgridchin
thank you, its right!
Electronics Forum | Mon Apr 16 13:31:36 EDT 2012 | jdengler
Have you tried to restart F4G and/or MCS/30 after flushing the CP4 memory? I have occasionally ran into the comm error after a reset start. Leave the machine on and restart F4G or the MCS/30 whichever normally is hooked up. If it still won't commu
Electronics Forum | Mon Apr 16 10:48:58 EDT 2012 | cyber_wolf
Sounds like a bad or out of adjustment servo amp.....
Electronics Forum | Tue Apr 17 13:07:17 EDT 2012 | rodrigo
Well... after much headache I found a bad relay contact in M1CR1E. The good news is somehow the axis are no longer jerking. The bad news is that it still does not work. When I turn it on now it shows this: emergency stop (in red) waiting for reset
Electronics Forum | Fri Mar 23 07:55:20 EDT 2018 | cyber_wolf
The shafts are not going to origin during zero set. Take a look at your station 12 sensors and fiber units.
Electronics Forum | Tue Apr 03 02:08:52 EDT 2018 | bukas
if you have any other questions about cp45 feel free to ask
Electronics Forum | Wed Apr 11 17:00:28 EDT 2012 | rodrigo
Hi all, Our cp4 moves rather violently (jerks) all axis when the reset sw is pressed after power up. I've got all sorts of errors after boot up: Servo amp error: D,X,Y, etc Overtravel D,X,Y, etc D clutch error, power off machine We've checked all
Electronics Forum | Thu Apr 12 17:49:35 EDT 2012 | rodrigo
I've done the Fuji flush. It does the same thing. We can not load proper again because it does not communicate with either the F4G or MCS/30. I was able to boot into mechanical mode at one point but now I can not do that either. This thing is drivi
Electronics Forum | Tue Apr 27 16:57:13 EDT 2004 | black5629
I have air, It start up and "About to Reset/press next to cont. When I press next nothing happens, if I press anything else "Machine not Reset" comes up. Can the axes be manualy reset? Thanks
Electronics Forum | Mon Sep 14 16:36:40 EDT 2015 | simons
Upon start up our QSA machine is giving us the following errors. Cant reset motor alarm (x axis) Cant reset motor alarm (y axis) Cant reset motor alarm (z axis) What are the possible reasons for this? Thanks
.gif)
