Electronics Forum | Thu Jun 21 12:18:47 EDT 2012 | swag
We use Hilman rollers (Hilmanrollers-mf.com) and/or pallet jacks. Printers and smaller P&P machines can be moved with pallet jacks. Large machines such as chipshooters require rollers and man power but you'd be amazed what you can push around on Hi
Electronics Forum | Fri Mar 15 08:20:06 EDT 2013 | torch
we quite often see this on our quads usually only on the 8mm feeders, sometimes the tape roller can become sticky as suggested. usually i just remove the roller and apply a grease to the screw so that it can move freely also make sure that the peel
Electronics Forum | Sat Apr 04 19:17:23 EDT 2015 | sync40
Hello to everybody. Does someone have some experience or review in the past with roller tinning machines? I mean low cost machines with two rollers and a molten solder tank. The finished soldermasked PCB pass through the rollers (like a lamination)
Electronics Forum | Fri Jul 16 08:05:44 EDT 2004 | cyber_wolf
In case anyone is interested, I found a solution to the problem. The 3 nylon rollers that the overlay tape rides on have a tendency to build up crud inside them. They may appear to function correctly when there is no overlay tape pushing on them, but
Electronics Forum | Thu Jan 26 18:28:40 EST 2006 | MikeAJ
An adhesive style cleaner is primarily used as a "precleaner" for bare boards only. These machines are placed between the loader and the printer. The TekNek machines can be best compared to those disposable lint and hair rollers. The same type of rol
Electronics Forum | Thu Dec 29 07:26:37 EST 2011 | janz
Hi, If this is sworf from pcb let say after routing of panel and sworf is attach to pcb cleaning with ultrasonics does not help unfortunatly. one of new cleaning technic which is worth to investigate is "snow jet". this is used during deburring and
Electronics Forum | Wed May 08 10:05:42 EDT 2002 | Claude_Couture
Maybe the problem is not the cutter, but the arm that advance the tape in the adjacent feeder gets actuated at the same time as the active feeder. line-up a feeder in pickup position visually, then turn the crank until the roller or feeder advance me
Electronics Forum | Mon Jul 03 03:42:32 EDT 2006 | teera
hello, pls check below item for paper stucks: 1)paper rolls diameter not over 60MM(new roll) 2)tension for roller clutch(silver u.s.c only) 3)make sure the under screen cleaner ROUGH ROLLER is clean and free for solder paste.so that it can turn smoot
Electronics Forum | Wed Dec 13 12:08:57 EST 2000 | Stefan Witte
Apparently the adhesive tape peels off from the joint, which could have some reasons. 1. There should be an overlap of the cover tape, as Cal mentioned. The new cover tape laying over the old by approx. 2mm. I also peel the cover tape a bit off, whi
Electronics Forum | Tue Jul 15 09:02:09 EDT 2008 | ehess
Has anyone using these ovens had any problems with the chain (flat) belt slipping? I suggested to the tech we remove a link in the flat chain, and he responded it would make it out of warranty. It's the same type of chain flat belt as most wash and