Electronics Forum | Thu Jun 08 18:40:44 EDT 2017 | simons
We have a Samsung that we have replaced all the amps and are still getting the Z axis motor alarm failure. On the “Position Window” before and after we try to “Home” the machine, the values for “Z-Axis” for all three heads prior to the “Home” action
Electronics Forum | Mon Jun 12 11:04:20 EDT 2017 | bobpan
So what your telling me is kind of vague. Does the machine home and go to the front left corner of the machine? If it does....this could be a quad align problem....meaning dirt on the lens or so-forth. You should watch the heads homing in the z-axi
Electronics Forum | Fri Mar 09 18:04:49 EST 2007 | Johnny
You can"t go wrong with Assembleon. I have been running a SMT line at my Co for 6 years with Gem machines and if I am paying for the line I would not even look at any other machine. Their tech support is first rate and even though we are a small Co
Electronics Forum | Thu Dec 15 23:04:07 EST 2005 | Manyhats
Hello, we are a low volume high mixed CM looking for a new addition to our SMT depot. We are currently running 2 Mydata TP-11 Hydra and feel that this can not meet our 06' forcast and current builds. I need to make a decision whether to go with the S
Electronics Forum | Mon Jun 12 17:54:17 EDT 2017 | simons
The machine does not move to the home position. Once we hit the "Home" button all three heads will move up to the "Home" position but then 5 to 10 seconds later the following error pops up "Error 1531 - Z Axis motor alarm" before any "xy" movement i
Electronics Forum | Mon Nov 19 17:43:16 EST 2012 | jaimebc
Theta error came back again during our first production run. Swaped motcards as a final attempt to find an easy fix and nothing. I swapped heads with another MYDATA to positively isolate the problem. And the theta error followed the head.
Electronics Forum | Tue Nov 15 19:31:54 EST 2005 | eeltec
>I/OPERATION ==> >1/RUNNING ==> but any command that I try gives an E100 error and in the left side of the monitor a square with: Conditions Initialized Waiting Emg stop (in red) org incmp (in red) Interlock (in red) data comp Use Vac
Electronics Forum | Thu Jan 11 05:58:35 EST 2007 | Peter
Hi All, We again have problem with Zevatech FS-730 This machine shows error E202162: "System error: T axis of center head: Parameter error when T axis performs PTP action.(Kind of unit)" and it stop running. It does not pick up components. At low spe
Electronics Forum | Sat Dec 01 18:08:03 EST 2007 | jmelson
Hello, I just ran into a crazy problem with my CSM84. I did a batch of one side of a board, then loaded the program to do the top side, and it stops with the head over the 3rd component's feeder, and reports error 117:overflow. The maintenance manua
Electronics Forum | Sun Dec 02 00:17:35 EST 2007 | jmelson
I finally figured it out - in my manual it shows as a "63:Overflow" and says it has run out of memory for management information. I finally realized they were talking about the MIS statistical data of feeders, heads and mounting programs. I cleared
