Electronics Forum | Fri Mar 24 15:01:47 EDT 2023 | previnmoore
sorry for the response taking so long, got wrapped up with another machine. It is the X axis.
Electronics Forum | Fri Mar 17 12:00:52 EDT 2023 | previnmoore
Its the kiss 103 selective solder machine. The end of the travel, it's the x axis. when i tried jogging it nothing happens just makes a noise. Thanks for responding.
Electronics Forum | Fri Mar 17 14:59:50 EDT 2023 | proceng1
OK, does your axis screw have the flex coupler or the magnetic coupler? Which axis is it? Did you turn off soft limits? If it's out of range, soft limits won't let it move by controls. I need to know which axis before I can get too far into this. I
Electronics Forum | Mon Aug 02 17:09:12 EDT 2021 | alexeyzb
What do you think about ZSWHPS-12S selective soldering machine? It looks like Ersa but more cheaper. Please, can you give me some advantages and disadvantages? I need facts, which i can check.
Electronics Forum | Tue Nov 14 16:06:27 EST 2000 | zorox
We have an ERSA machine here where we have solder "spikes" occasionally. We have made sure our flux is dispensing properly, we have adjusted z axis speeds, our preheater is heating properly, adjusted XY speeds, etc. Can anyone think of something we m
Electronics Forum | Fri Nov 14 10:40:35 EST 2014 | eniac
I use a two machines from EBSO, Germany. It's a machines with PCB carrier, so, solder pot is fixed. I'm fully satisfied with this equipment, but I use only wettable nozzles. If you would like to buy a new machine, not in used condition, EBSO will be
Electronics Forum | Mon May 01 10:55:21 EDT 2017 | tombstonesmt
This has already been done. Companies like Seho Selective Solder machines can provide this service. I imagine it is not cheap. I'd be curious to compare the drop rate of parts per person per hour on a couple of Pillarhouse Jades vs on custom machine.
Electronics Forum | Mon Nov 10 08:53:23 EST 2014 | jpal
We have the opportunity to buy a new selective solder machine and are used to using a very old Jade machine with a moving tank and wetted nozzle. I have two process concept questions: Which is better- move the board over the nozzle or move the nozz
Electronics Forum | Fri Nov 14 09:47:19 EST 2014 | jpal
Thanks for all the remarks. I am tending toward the move the pot method. I am concerned about parts tilting from square if moved or held at an angle. I won't need to deal with board pallets, board clamp mechanisms, etc. Plus I found the moving board
Electronics Forum | Sat Jun 24 07:23:06 EDT 2017 | tch
You will need to preheat the boards for a lead free selective solder process. A preheat module is critical for any wave or selective solder process, if you don't get the board preheated properly the solder is going to resist flowing to the top of the
