Electronics Forum | Fri Apr 29 10:19:23 EDT 2005 | mmjm_1099
Don't toss them the cost is crazy on this. I would send a tube in to get evaluated and talk to the maunfacturer than go from there.
Electronics Forum | Thu Mar 22 17:38:44 EST 2001 | davef
OK, lemme take a different angle on this, �cuz I forgot to touch on this when I first responded. I mentioned a study ["Evaluation of Low Residue Soldering for Military and Commercial Applications: A Report from the Low-Residue Soldering Task Force"
Electronics Forum | Tue Mar 06 09:18:33 EST 2001 | davef
Two things: 1 Go to IPC and buy "TP-1115 - Selection & Implementation Strategy for A Low-Residue No-Clean Process - Provides direction to electronics manufacturers interested in adopting low residue (LR) assembly technology. It addresses the concern
Electronics Forum | Tue Apr 17 21:30:27 EDT 2001 | davef
The issue is on the table. Which is it? Are you ... * Loosing your gold plate when you remove the tape? [A tape test is a standard test for evaluating gold fingers. Check IPC-TM-650, test number wachacallit. Checkitaut.] OR * Putting tape o
Electronics Forum | Thu Apr 26 16:43:16 EDT 2007 | Upper Management
Seminars and meetings are the best way to get a clear understanding of a machine's capabilities. I have found that the manufacturing engineers will oftentimes skew the results of machine evaluations with facts and data. In practice, I've found it
Electronics Forum | Wed Apr 16 10:45:16 EDT 2003 | Takfire
Recent cross-section analysis for a customer complaint revealed voiding in the solder fillet. In some cases, the remains of outgassing were also observed. During the failure analysis, we also observed failures where the solder fillet wicked on the
Electronics Forum | Sat Nov 07 10:09:52 EST 2009 | ramses2001
Hi Nemo, In my factory we have an offline AOI from VISCOM for two SMT lines. It's not so easy to program, but the results are very good. Anyway you should have to think that an AOI system needs a human inspector and a technician to debug the program
Electronics Forum | Thu Aug 10 13:16:17 EDT 2000 | Bob Willis
Here is some thing that I wrote a while back on solder beading. First what is a Solder Bead? The term solder bead is used to differentiate it from solder balls. A solder bead is a solder ball but its location is normally constant unlike solder bal
Electronics Forum | Thu Oct 20 15:10:26 EDT 2005 | IRAS
Can someone tell me where I can get the Benchmarker II coupon for solder paste evaluation.
Electronics Forum | Tue May 27 11:59:14 EDT 2003 | blnorman
Is anyone aware of any reports, studies, articles on the subject of silicon contamination in SnPb solder joints. We are evaluating repair of conformally coated (silicone) boards. The fear is that we will never totally remove the silicone and once i