Electronics Forum: solder paste (Page 2 of 660)

solder paste

Electronics Forum | Thu Dec 10 12:53:12 EST 2009 | deanm

Bryan, Dyoungquist is correct. You should not need to mix solder paste. Overmixing solder paste can adversely affect it. Follow these guidelines and you should be fine: 1. Keep unopened containers of paste in the refrigerator. 2. Take one container

solder paste

Electronics Forum | Fri Jul 29 10:03:02 EDT 2011 | blnorman

At a previous location we used the Semco cartridges. Occasionally the operator would have to scrape down the stencil and knead the paste back in. That would keep the paste on the edges from drying out. It was just standard procedure.

solder paste

Electronics Forum | Wed Dec 09 03:34:06 EST 2009 | cunningham

Sorry i wasnt very clear we already have a Malcolm sps-1 for our tubs but to move over to cartridges we need a machine to do that none of those machines are capable of mixing a 6 oz cartridge

solder paste

Electronics Forum | Wed Jul 27 10:07:16 EDT 2011 | swag

We bought air dispenser guns that fit the cartriges. I can't remember where we got them - sorry. We built little aluminum "holsters" for the sides of the machines to put the guns in. The guns are hooked up to air with low pressure regulators. Wor

solder paste

Electronics Forum | Fri Dec 11 09:51:56 EST 2009 | dyoungquist

I won't say never but very rarely do we have problems with the flux seperating. The way we get around the 1-2 hour warmup time is this: The day before we run a particular job, the last person takes out the paste needed from the fridge as the last t

solder paste

Electronics Forum | Wed Dec 09 09:47:32 EST 2009 | dyoungquist

I am curious as to why you need to mix.... We use a 500g cartridge with air gun. Our process is remove the cartridge from the fridge, allow it to warm up to room temperature before inserting into air gun, then apply bead of paste to the stencil. N

solder paste

Electronics Forum | Thu Dec 10 12:57:25 EST 2009 | scottp

We've used mostly cartridges for many years and I only saw separation once when a particular paste supplier had a problem. With cartridges it's just thaw and use - no mixing. We have some sites that use jars along with mixers and I've never been co

solder paste

Electronics Forum | Thu Jul 28 07:23:24 EDT 2011 | scottp

My group supports a couple hundred lines all over the world. Most of them use squeegees but a few use either the MPM Rheometric pump heads or the DEK Proflow heads. I absolutely hate the enclosed heads. Flux separation, compaction, and the print q

solder paste

Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef

Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c

expired solder paste

Electronics Forum | Mon Apr 07 19:12:13 EDT 2008 | kircchoffs

can we use the expired solder paste and put in a solder pot of wave machine?


solder paste searches for Companies, Equipment, Machines, Suppliers & Information