Electronics Forum | Mon Oct 10 15:24:15 EDT 2005 | zl3vlf
Hello to all! Our Fuji FIP-3 placement machine has come up with a servo alarm (X2-axis) whenever we try to run the machine. The manuals don't go into a lot of detail as to the cause of this problem, but there is plenty of information on what the X2
Electronics Forum | Fri Feb 01 01:46:46 EST 2008 | jola
Hi. There is no problem with the exhaust system and the owen also has a sensor to messure the exhaust and would give an alarm if it stopped or went under a preset value. We have had our owens for one year now and the problem just started suddenly, we
Electronics Forum | Thu Mar 30 13:27:53 EST 2006 | bvdb
Just before Christmas we bought a used Fuji IP1 cheap. It took us a while but it's been working great for about a month. Yesterday the IP1 stopped after completing a board but before exiting the board out the conveyer. No error message, no alarm be
Electronics Forum | Thu Aug 21 16:33:49 EDT 2008 | decaire
The 2 most common approaches for MSD Tracking and Control on the factory floor are: 1) Manual paper-based procedures (Example: Log Sheet or Label that the operator must fill out and pay attention to) - or - 2) Software-based tracking system (Example
Electronics Forum | Thu Sep 15 18:02:52 EDT 2005 | GAK
If the end sensor is bad it will cause the axis to past it and travel against the end stop and cause an over current also. So it kind of depends on what the machine is trying to do.
Electronics Forum | Wed Jun 09 10:41:28 EDT 2010 | chrislyttle
We've been having some problems with out Fuji IP2E machine that we've recently bought from a company that is no longer operating here. Since installing it we've encountered a few problems with it starting up. To give you a quick breakdown of its be
Electronics Forum | Sat Oct 10 02:59:53 EDT 2015 | aemery
AVCOM, I have worked on a few of the Conceptronic ovens recently for one of my clients. They had a similar issue, all the heaters dropping out with a high temp circuit error which kicks out CON1 (Heater power). If you're saying what I think your sa
Electronics Forum | Tue Apr 17 13:07:17 EDT 2012 | rodrigo
Well... after much headache I found a bad relay contact in M1CR1E. The good news is somehow the axis are no longer jerking. The bad news is that it still does not work. When I turn it on now it shows this: emergency stop (in red) waiting for reset
Electronics Forum | Thu Jun 08 18:40:44 EDT 2017 | simons
We have a Samsung that we have replaced all the amps and are still getting the Z axis motor alarm failure. On the “Position Window” before and after we try to “Home” the machine, the values for “Z-Axis” for all three heads prior to the “Home” action
Electronics Forum | Thu Feb 01 02:36:40 EST 2007 | bvdb
Hi pr, The problem was happening on all three of the nozzles that we were using, about half the time the Z axis would rise up and go for the next nozzle and the other half it would stop almost as soon as it released the nozzle. When I inch the Z ax