Electronics Forum | Mon Jun 26 03:56:44 EDT 2006 | slaine
hi I had a hunt round this morning and found all the schematic drawings for the vip70. Have you got a copy of them? where abouts in the uk are you im in Cumbria. drawing 5061617 appears to show some different wiring configerations, but im not sure if
Electronics Forum | Mon Jun 26 10:39:59 EDT 2006 | stepheniii
Have you considered selling the one you have there and buying a used one in N.A.? Might be more efficient. You are on 50Hz, right? I'm 99% sure Mexico is same as us at 60Hz.
Electronics Forum | Thu Jun 22 03:24:20 EDT 2006 | slaine
Hi Im in the UK and have a BTU VIP70. BTU UK are normally quite helpfull, and will probably explain whats involved if you phone them ask for a guy called Tim Hogarth. My guess is it will need a new transformer and rectifier but im more electronics th
Electronics Forum | Mon Jun 26 04:41:06 EDT 2006 | dallen
Thanks for all the responses. BTU has now informed that the reason it is so expensive is the oven heaters need completely rewiring and some work in the transformer area etc is required. Also, we have to pay for engineering work for them to know wha
Electronics Forum | Wed Jun 21 16:30:07 EDT 2006 | GS
Hi Dallen, I do not know BTU VIP70 oven, any way make sure if it is not yet wired for 480 V 3Ph (wiring diagram), may be it needs just to reset wiring on terminal block in order to run at 480V. Best if you ask BTU. If not, you have to buy a Transfo
Electronics Forum | Tue Jun 27 13:38:35 EDT 2006 | ChrisG
Stephen has a good point. You could buy a used oven. I know of several used ones that are completely refurbished for about 15-25K. But these are BTU P-70's and P-98's. The main problem here is frequency. Most of their ovens operate at 50 or 60
Electronics Forum | Sun May 13 22:55:03 EDT 2001 | zam_bri
Solder paste supplied in Catridge vs Jar. What is the pros and cons ? /zam_bri
Electronics Forum | Fri Jan 29 10:53:13 EST 2010 | jeffharley
There are pots on the board in the power supply to adjust the voltages after the machine is powered up. The location of these pots are in the munual supplied with the machine
Electronics Forum | Mon Jan 25 17:13:53 EST 2010 | bing007
I am working on a vcd 8 with a problem of loosing the 5 volts supply. We have fitted a new supply that also provides the 15 volts. When we remove the connector on the power chassis for the 5 volts the power supply shows OK. When fitted the 5 volts is
Electronics Forum | Wed Feb 03 18:29:46 EST 2010 | mika
4.85 V - 5.2 Volts. That is on the computer power inlet, Not the on the power supply. /Best Regards