Electronics Forum | Tue Sep 02 13:35:29 EDT 2008 | evtimov
Hi, I don;t thing there is an overtemperrature sensor. Just the thermocpouple returns a higher temp(voltage) to the controller and your software goes to alarm, cooldown or what ever it does. Emil
Electronics Forum | Mon Sep 01 04:55:20 EDT 2008 | benefon
Hello all Our Omni 5 has given the 'Cooling module high temp' warning twice during the past month. I suspect that the blower motor is the culprit but have not been able to verify this because the oven has started up normally after acknowledging the
Electronics Forum | Tue Apr 24 21:00:58 EDT 2018 | marlonbc
Hi All, Would just like to course through this concern on a product that we are contracted to assemble. It is mainly used for an automatic hand sanitizer dispensing product. By design there is a restrictive value of current that it needs to dissipat
Electronics Forum | Sat Feb 22 09:47:44 EST 2020 | tomdegas
When I run the "Service" software and I look at the status of the HYDB in the Utilities tab, it comes back with all is good except that the Hydra motor temperature sensor is "disconnected". Can anyone tell me where this sensor is and is it replaceabl
Electronics Forum | Mon Jun 27 14:44:47 EDT 2022 | kelvinchoong
Hi Sir, The VP Machine that i am currently using takes reference from its own temperature sensor. so most of the time i would have to adjust multiple times for my PCB to soak at the right temperature or reflow for the duration that i need it to. Fo
Electronics Forum | Sat May 26 00:32:55 EDT 2007 | crashoveride
it'll be cheaper if you'll let your wave machine up all night and let it in its idle temp (supposed to be 200��C) simply because it will need less power from idle temp up to operational temp compared to from 0�C-operational temp. Temperature Sensors
Electronics Forum | Tue Jan 11 11:50:35 EST 2005 | Shean Dalton
Consider these three potential causes: 1) too much sludge - if the sludge builds up around or over the temperature sensor, then the sensor does not get an accurate reading. 2) too much chemistry in the evaporation solution - Check the temperature a
Electronics Forum | Thu Apr 30 05:22:40 EDT 2020 | bobpan
There is a sensor that monitors the temperature of the x and y1/y2 axis on the machine. You have a possible problem with the x temp sensor. There is also a temperature board that is located in the leg area below the keyboard. I am attaching a picture
Electronics Forum | Wed Sep 20 10:42:05 EDT 2000 | Erick Russell
Process control for Photonic soldering is based on the actual temperature of the component being reworked. If the desired temperature of the component for your process is 200C then that is the process temperature programmed. This is achieved by a cl
Electronics Forum | Tue Nov 01 01:36:27 EST 2005 | mki
Hi, I am looking for opinion about possibility to do BGA rework with SRT-FPD? This early model (before 2000) is equiped with "Variable Perimeter Heater" (VPH). For BGA rework, SRT introduced later "Summit" models with removable nozzles. I am wonderin
.gif)
