Electronics Forum | Tue Feb 18 14:46:38 EST 2020 | bilalfarooqi
Hi all, We were able to fix the issue. We replaced the MOT cards with the MOT cards in the good machine. That, however, did not resolve the issue. The issue was very basic; one of the fuses (fi fuse) located to the left of the MOT cards became open.
Electronics Forum | Fri Feb 14 16:01:28 EST 2020 | bk
On the my12 the panel on the front of the machine comes off two screws each corner to loosen the panel. There is a pull out tray that gives you easier access to the computer, ps3, etc. It will be the box in the center on top it should label where eac
Electronics Forum | Tue Nov 13 11:41:23 EST 2012 | dontfeedphils
I can't remember what motor control cards in the machine are interchangeable, but if the controller card for the theta axis is a common control card then you can swap out the one currently controlling the theta axis with a different axis and see if t
Electronics Forum | Tue Oct 14 09:22:51 EDT 2014 | rgduval
Deni, Do you know if the theta axis controlled by the same slots/cards as the z-axis, by any chance? We also can't get theta to work on head 2, so, I'm wondering if the issue is related... thanks, ..rob
Electronics Forum | Wed Jun 24 16:10:09 EDT 2020 | landrysmt
Hello, Finaly, What was the problem on your Hydra head? Maybe my message comes too late, but my answer might help ... It could be linked to a problem with the Hydra Z motor / encoder. In certain circumstances, the Hydra Z axis is not in the correct
Electronics Forum | Sat Feb 15 13:06:00 EST 2014 | bobpan
This is a theta axis head 2 error. Manually spin the head and make sure the bearings are loose and spinning. If not, they may need lubricated or serviced. You can also swap theta amps between the heads to see if you have an amplifier problem. Good L
Electronics Forum | Wed May 08 05:13:37 EDT 2013 | bobpan
Put up an e-mail address and i can send you a paper on setting up the current level to see if the board is working properly. The z-axis and theta-axis are swappable.....you just need to change the dip switch settings.
Electronics Forum | Thu Nov 04 06:46:19 EDT 2010 | adriana
We find the problem on Servo Pack for F theta axis .The component QM20TD-H Mediu power Switching is damaged! Many thanks!
Electronics Forum | Mon Sep 16 00:30:56 EDT 2013 | larrygroves
likely something loose in the z or theta axis. Motor overruns and is corrected but goes too far then gets corrected back. it sets up an vibration and can make a lot of noise. best guess is that the spring is broke in the z rack.
Electronics Forum | Thu Mar 25 16:29:39 EDT 2021 | jdengler
Your missing the point. The placement machine is the primary issue. Does this toy even say it can handle that component? If you have the ability try slowing the machine down when it is placing that component. Slow X, Y, and Theta axis. Jerry
