Electronics Forum | Mon Apr 16 18:53:14 EDT 2012 | action_101
What is that garbage. How about you add flamer to like and dislike. I would have used it at least 3 times in this thread alone.
Electronics Forum | Tue Apr 10 04:16:20 EDT 2012 | grahamcooper22
you are seeing a typical issue that is caused when such small volumes of paste are printed....there are several reasons for it..the tiny amount of flux in the small deposit becomes exhausted much quicker then it does in a larger deposit ( the flux ma
Electronics Forum | Tue Jan 29 10:17:02 EST 2019 | bane016
I want to know how you measure capacitance and resistance to 01005 components?Is there such a machine for automatic measurement of component values on PCB? We have a lot 01005 components and we lose time to measure first panel components...I'm inter
Electronics Forum | Thu Jul 15 15:16:26 EDT 2010 | leemeyer
I am looking into pick and place machines that are spec'd to place 01005 components. Does anyone know of a inexpensive make(50 - 75K $ new) that can place these parts. So far all that I have found are 150K and up. Thanks
Electronics Forum | Thu Jul 15 16:22:22 EDT 2010 | wrongway
If you found one for that price would you realy trust that it would be as good as you would need it to be
Electronics Forum | Tue Jan 29 16:54:17 EST 2019 | slthomas
There's always flying probe, although it's not particularly cheap.
Electronics Forum | Wed Jan 30 02:56:22 EST 2019 | robl
I'm with Steve and flying probing. As long as you are testing the capacitance of the cap in the circuit and not of the cap itself you'll get a pretty good indication. Most are going to be 10nf and 100nf decoupling caps at that size so quite easy to
Electronics Forum | Wed Jan 30 03:20:00 EST 2019 | bane016
We measure each first board before the oven after every chageover...Assembling one offset and measure component, after we clear plate...We have reason why do that...But we're wasting a lot of time.So I wanted to see how you do it. Thank you for answe
Electronics Forum | Tue Jan 29 20:33:52 EST 2019 | deanm
First, you cannot measure capacitors once they are soldered onto the board. Second, why must you measure? Verify your machine set up by using intelligent feeders (if your machine has them) or a checklist, preferably by two people. If you cannot trus
Electronics Forum | Thu Feb 13 03:49:15 EST 2014 | jlawson
Yes all above is correct, as solder deposits get smaller and mesh T4+ , actual metal to air contact surface area increases , say in contrast to T3, add to this less flux , and flux running away from the joint, re-oxidation and what flux is left, can
